Owner's Manual - Roland

Creating a PerformancePart LevelAdjust the volume of each part. This setting’s main purpose is toadjust the volume balance between parts.Value: 0–127Part PanAdjust the pan of each part. “L64” is far left, “0” is center, and “63R”is far right.Value: L64–0–63R[F2 (Output Effect)]fig.09-002_50• Chorus and reverb are output in mono at all times.• The output destination of the signal after passing through thechorus is set with the Chorus Output Select (p. 209) and theChorus Output Assign (p. 209).• The output destination of the signal after passing through thereverb is set with the Reverb Output Assign (p. 209).Part Output MFX Select (Part Output Multi-Effects Select)Of the three types of multi-effects that can be used simultaneously,specify which multi-effects will be used.Value: 1–3 (MFX-1–MFX-3)Part Output LevelSet the level of the signal that is sent to the output destinationspecified by Part Output Assign.Value: 0–127Part Chorus Send LevelSets the level of the signal sent to chorus for each part.Value: 0–127Part Reverb Send LevelFor details on these settings, refer to “Adjusting theParameters of Each Part” (p. 107).Part Output AssignSpecifies for each part how the direct sound will be output.ValueMFX: Output in stereo through multi-effects. You can alsoapply chorus or reverb to the sound that passes throughmulti-effects.A, B: Output to the OUTPUT A (MIX) jack or OUTPUT B jackin stereo without passing through multi-effects.1–4: Output to the INDIVIDUAL 1–4 jacks in mono withoutpassing through multi-effects.PAT: The part’s output destination is determined by thesettings of the patch or rhythm set assigned to the part.Sets the level of the signal sent to reverb for each part.Value: 0–127MFX1–3 SourceChorus SourceReverb SourceThe settings of a specific patch can be used as the settings for MFX1(1)–MFX3 (3), chorus (C), and reverb (R). This setting specifies thepart to which this patch has been assigned.If no part is selected, the settings of the Performance will be used.For the following parameters, settings can be made individuallyfor each multi-effects (MFX1–MFX3) selected in Part OutputMFX Select.If you've made settings so that sounds are separately routed tothe INDIVIDUAL 1 jack and INDIVIDUAL 2 jack, but no plugis actually inserted in the INDIVIDUAL 2 jack, the soundsrouted to INDIVIDUAL 1 and INDIVIDUAL 2 will be mixedand output from the INDIVIDUAL 1 jack.If the Mix/Parallel parameter is set to “MIX,” all sounds areoutput from the OUTPUT A (MIX) jacks in stereo (p. 230).If you've set Tone Out Assign to “MFX,” set the MFX OutputAssign parameter to specify the output destination of the soundthat has passed through the multi-effects.108