Owner's Manual - Roland

Playing in Performance ModeCombining and Playing SoundsTogether (Layer)In Performance mode you can play the sounds of all parts whoseInternal Switch is on, and all connected parts. Combining the partswill produce, thicker, fatter sounds.fig.08-009.eA split performance is one application of a layer. Changing thekey range of each part in the layer results in a split.1. Press [LAYER/SPLIT] to access the Layer screen.2. Press or to select the part you want to play.3. Press [F3 (Key Range)].Part 1(Rx ch.1)Part 2(Rx ch.2)Part 15(Rx ch.15)Part 16(Rx ch.16)4. Press [F3 (KBD)], move the cursor to the keyboard switch,and press [INC] to turn on the keyboard switch that isconnected to the part you want to sound.KBD Switch:On5. To set the lower limit of the range, use [F4 (Lower)] to movethe cursor to “Key Range Lower.” To set the lower limit ofthe range, use [F5 (Upper)] to move the cursor to “KeyRange Upper.”Turn the VALUE dial or press [INC]/[DEC] to specify therange.1 (Tx ch.1)2 (Tx ch.2)The bar shown above the keyboard indicates the range of keysthat will sound.Rx ch.: Receive ChannelTx ch.: Transmit Channel15 (Tx ch.15)16(Tx ch.16)If you attempt to set the lower limit higher than the upper limit,or attempt to set the upper limit below the lower limit, the othersetting will change with the same value.fig.08-011_501. Press [LAYER/SPLIT] to access the Layer screen.2. Press or to select the part you want to play.The Performance Edit screen appears.3. Press [INC] to add a check mark to the part that you want tosound.Pressing [DEC] will remove the check mark.The bar shown above the keyboard indicates the range of keysthat will sound.When you play the keyboard, you will hear the current part andthe parts whose keyboard switch has a check mark.4. Repeat steps 2. 3. to turn the Internal Switch on for all partsthat are connected to the parts you want to play.Playing Different Sounds inDifferent Areas of the Keyboard(Split)In Performance mode you can divide the keyboard and play adifferent patch in each area (this is called “split”). As the note rangethat plays each part can be specified individually, you can split thekeyboard into a maximum of 16 sections.For instance, you can play strings in the lower range, piano in theupper range, and both sounds in the middle range.fig.08-010.eValue:Key Range Lower: C-1–UPPERKey Range Upper: LOWER–G9By specifying sections for different parts so that they overlapeach other, you can combine two or more parts only in a specificsection.6. When you are finished making settings, press [F8 (Close)]to return to the Performance Layer screen, and beginplaying.Part 1: StringsPart 1 + Part 2:(Strings + Piano)Part 2: Piano102