SCSI Primary Commands - 2.pdf

18 July 2001 T10/1236-D Revision 208.2.2 Application client pageThe application client page (see table 127) provides a place for application clients to store information. The pagecode for the application client page is 0Fh.Table 127 — Application client pageBitByte7 6 5 4 3 2 1 00 PAGE CODE (0Fh)1 Reserved2 (MSB)PAGE LENGTH (n-3)3 (LSB)Application client log parameters4First application client log parameter..nLast application client log parameterThe PAGE CODE and PAGE LENGTH fields are described in 8.2.1.Parameter codes 0000h through 0FFFFh are for general usage application client data. The intended use for thisinformation is to aid in describing the system configuration and system problems, but the exact definition of the datais application client specific. The general usage application client data parameters all have the format shown intable 128.Table 128 — General usage application client parameter dataBitByte7 6 5 4 3 2 1 00 (MSB)PARAMETER CODE1 (LSB)2 DU DS TSD ETC TMC LBIN LP3 PARAMETER LENGTH (FCh)4255GENERAL USAGE PARAMETER BYTESFor general usage application client data, the value in the PARAMETER CODE field shall be between 0000h and0FFFh. The first supported general usage application client parameter code shall be 0000h and additionalsupported parameters shall be sequentially numbered. If any general usage parameter codes are implemented,the device shall support at least 64 general usage parameter descriptors and they shall be parameter codes 0000hthrough 003Fh.For the general usage application client parameter, the PARAMETER LENGTH value for each parameter shall be FCh.dpANS SCSI Primary Commands - 2 (SPC-2) 177