SCSI Primary Commands - 2.pdf

More documents

Recommendations

Info

T10/1236-D Revision 20 18 July 2001Table 107 — Sense key descriptions (part 2 of 2)Sensekey5h6h7h8h9hAhBhChDhEhFhDescriptionILLEGAL REQUEST. Indicates that there was an illegal parameter in the CDB or in the additionalparameters supplied as data for some commands (e.g., FORMAT UNIT or SEARCH DATA). If thedevice server detects an invalid parameter in the CDB, then it shall terminate the command withoutaltering the medium. If the device server detects an invalid parameter in the additional parameterssupplied as data, then the device server may have already altered the medium.UNIT ATTENTION. Indicates that the removable medium may have been changed or the targethas been reset. See SAM-2 for more detailed information about the unit attention condition.DATA PROTECT. Indicates that a command that reads or writes the medium was attempted on ablock that is protected from this operation. The read or write operation is not performed.BLANK CHECK. Indicates that a write-once device or a sequential-access device encounteredblank medium or format-defined end-of-data indication while reading or a write-once deviceencountered a non-blank medium while writing.VENDOR SPECIFIC. This sense key is available for reporting vendor specific conditions.COPY ABORTED. Indicates an EXTENDED COPY command was aborted due to an errorcondition on the source device, the destination device, or both (see 7.2.3).ABORTED COMMAND. Indicates that the device server aborted the command. The applicationclient may be able to recover by trying the command again.ObsoleteVOLUME OVERFLOW. Indicates that a buffered SCSI device has reached the end-of-partitionand data may remain in the buffer that has not been written to the medium. One or moreRECOVER BUFFERED DATA command(s) may be issued to read the unwritten data from thebuffer. (See SSC.)MISCOMPARE. Indicates that the source data did not match the data read from the medium.Reserved142 dpANS SCSI Primary Commands - 2 (SPC-2)
18 July 2001 T10/1236-D Revision 20The additional sense codes and additional sense code qualifiers are defined in table 108.Table 108 — ASC and ASCQ assignments (part 1 of 13)D - DIRECT ACCESS DEVICE (SBC)Device Column key. T - SEQUENTIAL ACCESS DEVICE (SSC) blank = code not used. L - PRINTER DEVICE (SSC) not blank = code used. P - PROCESSOR DEVICE (SPC-2). . W- WRITE ONCE READ MULTIPLE DEVICE (SBC). . R - C/DVD DEVICE (MMC-2). . S - SCANNER DEVICE (SCSI-2). . . O - OPTICAL MEMORY DEVICE (SBC). . . M- MEDIA CHANGER DEVICE (SMC). . . C - COMMUNICATION DEVICE (SCSI-2). . . . A- STORAGE ARRAY DEVICE (SCC). . . . E- ENCLOSURE SERVICES DEVICE (SES). . . . B- SIMPLIFIED DIRECT-ACCESS DEVICE (RBC). . . . . K- OPTICAL CARD READER/WRITER DEVICE (OCRW). . . . .ASCASCQ DTLPWRSOMCAEBK Description67h 02h A ADD LOGICAL UNIT FAILED13h 00h D W O B K ADDRESS MARK NOT FOUND FOR DATA FIELD12h 00h D W O B K ADDRESS MARK NOT FOUND FOR ID FIELD67h 08h A ASSIGN FAILURE OCCURRED27h 03h T R ASSOCIATED WRITE PROTECT47h 04h DTLPWRSOMCAEBK ASYNCHRONOUS INFORMATION PROTECTION ERROR DETECTED67h 06h A ATTACHMENT OF LOGICAL UNIT FAILED00h 11h R AUDIO PLAY OPERATION IN PROGRESS00h 12h R AUDIO PLAY OPERATION PAUSED00h 14h R AUDIO PLAY OPERATION STOPPED DUE TO ERROR00h 13h R AUDIO PLAY OPERATION SUCCESSFULLY COMPLETED66h 00h S AUTOMATIC DOCUMENT FEEDER COVER UP66h 01h S AUTOMATIC DOCUMENT FEEDER LIFT UP00h 04h T S BEGINNING-OF-PARTITION/MEDIUM DETECTED0Ch 06h D T W O B BLOCK NOT COMPRESSIBLE14h 04h T BLOCK SEQUENCE ERROR29h 03h DTLPWRSOMCAEBK BUS DEVICE RESET FUNCTION OCCURRED11h 0Eh D T W R O B CANNOT DECOMPRESS USING DECLARED ALGORITHM30h 06h D T W R O B CANNOT FORMAT MEDIUM - INCOMPATIBLE MEDIUM30h 02h D T W R O B K CANNOT READ MEDIUM - INCOMPATIBLE FORMAT30h 01h D T W R O B K CANNOT READ MEDIUM - UNKNOWN FORMAT30h 08h R CANNOT WRITE - APPLICATION CODE MISMATCH30h 05h D T W R O B K CANNOT WRITE MEDIUM - INCOMPATIBLE FORMAT30h 04h D T W R O B K CANNOT WRITE MEDIUM - UNKNOWN FORMAT52h 00h T CARTRIDGE FAULT73h 00h R CD CONTROL ERROR24h 01h DTLPWRSOMCAEBK CDB DECRYPTION ERROR3Fh 02h D T L P W R S O M C B K CHANGED OPERATING DEFINITION11h 06h W R O B CIRC UNRECOVERED ERROR30h 03h D T R K CLEANING CARTRIDGE INSTALLED30h 07h DTL WRSOM AEBK CLEANING FAILURE00h 17h DTL WRSOM AEBK CLEANING REQUESTED4Ah 00h DTLPWRSOMCAEBK COMMAND PHASE ERROR2Ch 00h DTLPWRSOMCAEBK COMMAND SEQUENCE ERROR6Eh 00h A COMMAND TO LOGICAL UNIT FAILED2Fh 00h DTLPWRSOMCAEBK COMMANDS CLEARED BY ANOTHER INITIATOR3Fh 04h DT WR OMCAEBK COMPONENT DEVICE ATTACHEDAnnex C contains the ASC and ASCQ assignments in numeric order.dpANS SCSI Primary Commands - 2 (SPC-2) 143
Page 1 and 2:
dpANSProjectT10/1236-DRevision 2018
Page 3:
DraftANSI (r)NCITS.351:200xAmerican
Page 6 and 7:
T10/1236-D Revision 20 18 July 2001
Page 8 and 9:
Page 10 and 11:
Page 12 and 13:
Page 14 and 15:
Page 16 and 17:
Page 18 and 19:
Page 20 and 21:
Page 22 and 23:
Page 24 and 25:
Page 26 and 27:
Page 28 and 29:
Page 30 and 31:
Page 32 and 33:
Page 34 and 35:
Page 36 and 37:
Page 38 and 39:
Page 40 and 41:
Page 42 and 43:
Page 44 and 45:
Page 46 and 47:
Page 48 and 49:
Page 50 and 51:
Page 52 and 53:
Page 54 and 55:
Page 56 and 57:
Page 58 and 59:
Page 60 and 61:
Page 62 and 63:
Page 64 and 65:
Page 66 and 67:
Page 68 and 69:
Page 70 and 71:
Page 72 and 73:
Page 74 and 75:
Page 76 and 77:
Page 78 and 79:
Page 80 and 81:
Page 82 and 83:
Page 84 and 85:
Page 86 and 87:
Page 88 and 89:
Page 90 and 91:
Page 92 and 93:
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111: T10/1236-D Revision 20 18 July 2001
Page 210 and 211:
Page 212 and 213:
Page 214 and 215:
Page 216 and 217:
Page 218 and 219:
Page 220 and 221:
Page 222 and 223:
Page 224 and 225:
Page 226 and 227:
Page 228 and 229:
Page 230 and 231:
Page 232 and 233:
Page 234 and 235:
Page 236 and 237:
Page 238 and 239:
Page 240 and 241:
Page 242 and 243:
Page 244 and 245:
Page 246 and 247:
Page 248 and 249:
Page 250 and 251:
Page 252 and 253:
Page 254 and 255:
Page 256 and 257:
Page 258 and 259:
Page 260 and 261:
Page 262 and 263:
Page 264 and 265:
Page 266 and 267:
Page 268 and 269:
Page 270 and 271:
Page 272 and 273:
Page 274 and 275:
Page 276 and 277:
Page 278 and 279:
Page 280 and 281:
Page 282 and 283:
Page 284 and 285:
Page 286 and 287:
Page 288 and 289:
Page 290 and 291:
Page 292 and 293:
show all

SCSI Primary Commands - 2.pdf

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?