EN / ACS800-31/U31 Hardware Manual - Simark Controls
EN / ACS800-31/U31 Hardware Manual - Simark Controls
EN / ACS800-31/U31 Hardware Manual - Simark Controls
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
91<strong>ACS800</strong>-<strong>31</strong>/U<strong>31</strong> specific parameters in the IGBT Supply Control ProgramThe signals and parameters of the IGBT Supply Control Program which are specificto the <strong>ACS800</strong>-<strong>31</strong> and <strong>ACS800</strong>-U<strong>31</strong> are described in the tables below. Theseparameters need not be set in a normal start-up. For more information onparameters of the IGBT Supply Control Program, refer to IGBT Supply ControlProgram Firmware <strong>Manual</strong> [3AFE68<strong>31</strong>5735 (English)].Terms and abbreviationsTermDefinitionBBoolean data typeCCharacter string data typeDef.Default value data typeFbEqFieldbus equivalent: the scaling between the value shown on the controlpanel and the integer used in serial communicationIInteger data typeRReal data typeT. Data type (see B, C, I, R)ParametersNo. Name/Value Description T./FbEq Def.Parameter lock, parameter back-up etc.16 SYSTEM CTRINPUTS16.15 I/O START MODE Selects I/O control start mode when par. 98.01 COMMAND SEL is setto I/O.DI2 EDGEStarts the line converter by digital input DI2 rising edge. The lineconverter starts to modulate and the charging resistors will be bypassedwhen the motor-side converter is started.DI2 LEVELStarts the line converter by the level of digital input DI2. The lineconverter starts to modulate and the charging resistors will be bypassedwhen the line converter RMIO board is powered, its digitalinput DI2 is ON and there are no faults.Note: This selection changes the value of par. 98.01 COMMAND SELfrom the default setting MCW to I/O on the next RMIO board powerup.B01DI2 EDGEActual signals and parameters
Change language