EN / ACS800-31/U31 Hardware Manual - Simark Controls

20ContentsThe chapters of this manual are briefly described below.Safety instructions give safety instructions for the installation, commissioning,operation and maintenance of the drive.About this manual lists the steps in checking the delivery and installing andcommissioning the drive and refers to chapters/sections in this manual and othermanuals for particular tasks.The ACS800-31/U31 describes the drive.Mechanical installation instructs in how to place and mount the drive.Planning the electrical installation instructs in the motor and cable selection,protections and cable routing.Electrical installation shows how to wire the drive.Installation of AGPS board (Prevention of Unexpected Start, +Q950) describes theelectrical installation of the optional Prevention of Unexpected Start function(+Q950).Motor control and I/O board (RMIO) shows the external control connections to theI/O board.Installation checklist contains a list for checking the mechanical and electricalinstallation of the drive.Start-up and use describes the start-up procedure and use of the drive.Actual signals and parameters contains listings of parameters specific to theACS800-31 and ACS800-U31.Maintenance contains preventive maintenance instructions.Fault tracing contains guide lines for fault tracing.Technical data contains the technical specifications of the drive, e.g. the ratings,sizes and technical requirements, provisions for fulfilling the requirements for CEand other markings and warranty policy.Dimensional drawings contains the dimensional drawings of the drive.Resistor braking describes how to select, protect and wire external brake choppersand resistors for the drive. The chapter also contains installation instructions and thetechnical data.External +24 V power supply for the RMIO boards via terminal X34 describes how toconnect an external +24 V power supply for the RMIO board using terminal X34.About this manual