EN / ACS800-31/U31 Hardware Manual - Simark Controls

110Motor connectionVoltage (U 2 )Frequency0 to U 1 , 3-phase symmetrical, U max at the field weakening pointDTC mode: 0 to 3.2 · f fwp . Maximum frequency 300 Hz.f fwp =U NmainsU Nmotor· f NmotorFrequency resolutionCurrentPower limitField weakening pointSwitching frequencyMaximum recommendedmotor cable lengthEfficiencyCoolingMethodFree space around the unitf fwp : frequency at field weakening point; U Nmains : mains (input power) voltage;U Nmotor : rated motor voltage; f Nmotor : rated motor frequency0.01 HzSee section IEC data or NEMA data.Approximately 1.3 · P cont.max8 to 300 Hz3 kHz (average).300 m (984 ft). Additional restriction for units with EMC filtering (type code selections+E202 and +E200): max. motor cable length is 100 m (328 ft). With longer cables the EMCDirective requirements may not be fulfilled.Approximately 97% at nominal power levelInternal fan, flow direction from bottom to top.See chapter Mechanical installation.Degrees of protectionAGPS-11CIP20 (UL type open) and IP21 (UL type 1). IPXXD from above.Without front cover, the unit must be protected against contact according to IP2x [seechapter Electrical installation: Cabinet installed units (IP 00, UL type open)].Nominal input voltage 115...230 VAC ±10%Nominal input current 0.1 A (230 V) / 0.2 A (115 V)Nominal frequency50/60 HzMax. external fuse16 AX1 terminal sizes 3 x 2.5 mm 2Output voltage15 VDC ±0.5 VNominal output current 0.4 AX2 terminal block type JST B4P-VHAmbient temperature 0...50°CRelative humidityMax. 90%, no condensation allowedDimensions (with enclosure) 167 x 128 x 52 mm (Height x Weight x Depth)Weight (with enclosure) 0.75 kgApprovalsC-UL, US listedTechnical data