EN / ACS800-31/U31 Hardware Manual - Simark Controls
EN / ACS800-31/U31 Hardware Manual - Simark Controls
EN / ACS800-31/U31 Hardware Manual - Simark Controls
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
93Fixed parameters with the <strong>ACS800</strong>-<strong>31</strong> and <strong>ACS800</strong>-U<strong>31</strong>When the IGBT Supply Control Program is loaded into the <strong>ACS800</strong>-<strong>31</strong> or <strong>ACS800</strong>-U<strong>31</strong>, the following parameters are set to the default values given in the table below.Parameter Default value If changed,11.01 DC REF SELECT FIELDBUS the default values will be11.02 Q REF SELECT PARAM 24.02restored on the next powerup.98.01 COMMAND SEL MCW. Note: If par. 16.15 I/OSTART MODE is set to DI2 LEVEL,the default value is changed to I/Oon the next RMIO board power-up.98.02 COMM. MODULE INVERTER30.02 EARTH FAULT FAULT.Note: The <strong>ACS800</strong>-<strong>31</strong>/U<strong>31</strong> lineconverter is not equipped withinternal earth fault supervision.70.01 CH0 NODE ADDR 12070.19 CH0 HW CONNECTION RING70.20 CH3 HW CONNECTION RING71.01 CH0 DRIVEBUS MODE NOthe default values will notbe restored on the nextpower-up. Do not change.If the default values arechanged, the drive will notoperate.Actual signals and parameters
Change language