PLCHandler Programming Guide - Esco Drives & Automation

PLCHandler Programming Guideproject= ProjektName.prodevice=Tcp/Ip (Level 2Route)instance=PLCWinNT_TCPIPparameters=4parameter0=Addressvalue0=localhostparameter1=PortOnly relevant in SIMULATION: in this case the PLCHandlerneeds no PLC, but simulates the PLC via the symbol file’ProjektName.sdb’.This entry also can be used in the ARTI Interface, if the SDBfile cannot be stored on the underlying PLC.Communication protocol; the most important settings are:Tcp/Ip (Level 4): TCP/IP Level 4 ProtocolTcp/Ip (Level 2): TCP/IP Level 2 ProtocolTcp/Ip (Level 2 Route): TCP/IP Level 2 RouteSerial (RS232): Serial connectionFor information on other protocols please see thecorresponding specification (see Gateway).Special: ELAU -> device = Tcp/IP (Level 4)Here you can assign a name to the package of configurationsettingsNumber of parameters for this protocol(here: TCP/IP Level 2 Route)Name of the first parameter: TCP/IP address of the PLCValue of first parameter: here: connection to localhostName of second parameter: Port Numbervalue1=1200 Value of second parameter: Default value 1200parameter2= TargetIdvalue2=0parameter3= Motorolabyteordervalue3=NoSpecial: ELAU -> value1 = 5000For TCP/IP (Level 2 Route): ID of the runtime system,to which the data should be routedFor TCP/IP (Level 2 Route): Default value 0 (norouting)Name of fourth parameter: Motorola byte order for thecommunication dataValue of fourth parameter: No -> no swapping necessary[PLC:RTE]interfacetype=GATEWAY...This is the second instance to be configuredInterface type: ARTI, SIMULATION, GATEWAY (gateway onlyunder WinNT/2000/XP) 3S - Smart Software Solutions GmbHPLCHandler Programmming Guide.doc Page 12 of 17