LEADTEK Wireless GPS Receiver User's Manual

More documents

Recommendations

Info

.2.3. Firmware CharacteristicsItemsCore of firmware SiRF version 2.3Baud rate 4800Code typeNMEA-0183 ASCIIDatumWGS-84Protocol messageOutput frequency 1 HzDescription3. Operation3.1. Hardware DescriptionThe Bluetooth GPS has two LED light which each has two colors. One is GPS & Chargestatus LED, that is named LED 2, and the other is Bluetooth & low power status LED, that is namedLED 1. The status table of LED shows as follows:LED1BT & Low Power LEDDescriptionLED1 Color and Action Bluetooth Active Low PowerBlue Flash Yes NoPurple–Red Flash Yes Yes- 4 -
.LED2GPS & Charge LEDDescriptionLED2 Color and Action Battery Charged Position FixedDark No NoGreen Flash No YesRed Yes NoOrange-Red Flash Yes YesWhen the Bluetooth is active and LED 1 lights, it shows Bluetooth RF function. As long asthe Bluetooth RF is transmitting the LED light will flash. When Bluetooth doesn’t connect the otherBluetooth device, the LED 1 will be flash periodically. Therefore, it means that it broadcasts messageto connect the other device with Bluetooth function. If it connects the other Bluetooth device andtransmits data, LED 1 will flash very quickly and look like bright.When the battery is charging, LED 1 will show purple-red color and flash. The reason thatBluetooth is working cause LED 1 purple-red color. If the GPS receiver go to the end of charge, LED1 will show blue color and flash.3.2. Turn on/offTurn on To turn on the receiver, press the power button on the topside briefly (0.5seconds). The left LED(LED 2) indicator will flash briefly. The right LED(LED 1) indicator will start flashing.Turn offTo turn off the receiver, press the power button on the topside for 3 seconds.The LED indicator will flash briefly before switching off the receiver.3.3. ChargingLow PowerChargingThe right LED(LED 1) indicator will turn RED (normally BLUE) when batterypower becomes low. Connect the receiver to a powers source to continueoperation and to recharge the battery.The left LED(LED 2) indicator will turn RED (or ORANGE) when the batteryis being charged. When fully charged, the RED indicator will switch off.3.4. Bluetooth CommunicationWaiting to connect The right LED(LED 1) indicator will flash if there is no communicationbetween the receiver and another device.Connected The right LED(LED 1) indicator will turn to continuous lighting when thereceiver is connected through the wireless link with another device.- 5 -
Page 1 and 2: .LEADTEK Wireless GPS ReceiverUser
Page 3 and 4: .1. Introduction1.1. OverviewThe Le
Page 5: .Output messageDefault output forma
Page 9 and 10: .5.5 BatteryThis product uses a Lit
Page 11 and 12: .2. BTWCE 1.1(1) Make sure that the
Page 13 and 14: .(5) Back to the main form of BTW-C
Page 15 and 16: .(7) As the connection being establ
Page 17 and 18: .(3) Click the “Bluetooth Manager
Page 19 and 20: .(7) Select the target and hold on
Page 21 and 22: .Step 2.The Add/Remove Programs dia
Page 23 and 24: .Step 5.When the installation is co
Page 25 and 26: .you have to get the authorized sof
Page 27 and 28: . In the Folders pane of My Bluetoo
Page 29: .Leadtek Research Inc.: 18F, 166, C

LEADTEK Wireless GPS Receiver User's Manual

Create successful ePaper yourself

Delete template?

Save as template?