LEADTEK Wireless GPS Receiver User's Manual
LEADTEK Wireless GPS Receiver User's Manual LEADTEK Wireless GPS Receiver User's Manual
.3. BTWCE 1.3(1) Make sure that the status of Bluetooth is on.(2) Change the page to “Serial Port”, then check which com port used as “OutboundCOM Port”. In this case, the number of com port is 6. And then change to “about”page, there should be version string shown.- 14-
.(3) Click the “Bluetooth Manager” in “General” page. Select “New” and “Connect!”to add new device.(4) Then the Bluetooth Connection Wizard will be executed. Select “Explore aBluetooth device” and click “Next”. Tab the Device frame on the form to start tosearch.- 15-
- Page 1 and 2: .LEADTEK Wireless GPS ReceiverUser
- Page 3 and 4: .1. Introduction1.1. OverviewThe Le
- Page 5 and 6: .Output messageDefault output forma
- Page 7 and 8: .LED2GPS & Charge LEDDescriptionLED
- Page 9 and 10: .5.5 BatteryThis product uses a Lit
- Page 11 and 12: .2. BTWCE 1.1(1) Make sure that the
- Page 13 and 14: .(5) Back to the main form of BTW-C
- Page 15: .(7) As the connection being establ
- Page 19 and 20: .(7) Select the target and hold on
- Page 21 and 22: .Step 2.The Add/Remove Programs dia
- Page 23 and 24: .Step 5.When the installation is co
- Page 25 and 26: .you have to get the authorized sof
- Page 27 and 28: . In the Folders pane of My Bluetoo
- Page 29: .Leadtek Research Inc.: 18F, 166, C
.(3) Click the “Bluetooth Manager” in “General” page. Select “New” and “Connect!”to add new device.(4) Then the Bluetooth Connection Wizard will be executed. Select “Explore aBluetooth device” and click “Next”. Tab the Device frame on the form to start tosearch.- 15-