FiberSource QFX 150 - SXS Events

More documents

Recommendations

Info

4 If clamping, bolt the clamps securely to the flanges with grade 8.8 (minimum)and Phone: courtesy Audio-Visual 0870 of 080 Services 2342M12 bolts and lock nuts, or as recommended by the clamp manufacturer,through the 13 mm holes. Install a safety cable that can hold at least 10 timesthe weight of the fixture through one of the small holes and around the truss orpipe. Remove a rubber washer if necessary to thread the safety cable.mail: www.sxsevents.co.uk5enquiries@sxsevents.co.ukVerify that the fixture is located at least 0.1 meters (4 in.) from any combustiblematerials. Verify that the clearance around the fan and air vents is at least 0.1meters (4 in.). Verify that there are no flammable materials nearby.www.sxsevents.co.uk10 Installation
and Audio-Visual Servicesmail: www.sxsevents.co.ukenquiries@sxsevents.co.uk5FIBER Phone: courtesy OPTIC CABLE 0870 of 080 2342The <strong>FiberSource</strong> male adaptor for 50 - 300 strand cables, P/N 91611016 (notincluded), is tapered to fit fiber optic cables 8.3 - 19.3 mm (5/16 - 3/4 in.) indiameter. With cables over 8.3 mm in diameter, the adaptor must be shortened forproper fit and maximum light output. Please follow the instructions included withthe fiber adaptor.CABLE CONNECTIONThe following guidelines provide a starting point for estimating your needs. Lighttransmission through fiber-optic cable depends on its quality and results will varydepending on the type of cable used.SIDE-EMITTING CABLEWith 1 fixture, best results are had when the fiber optic cable is 10 m (33 ft.) orshorter. The length may be increased to 15 m (50 ft.) by looping the cable andilluminating both ends. With 2 fixtures, one at each end of the cable, lengths up to30 m (100 ft.) can be achieved.END-EMITTING CABLELight output decreases with length: keep the cable as short as possible. Themaximum recommended length is 25 meters. Cut the light emitting end of the fiberswith a sharp knife for maximum output.To install fiber optic cable1 Install the cable in the fiber adaptor according to the instructions packagedwith the adaptor.2 Insert the adaptor fully into the fiber optic cable socket.3 Tighten the set screw with a 2 mm (5/64 in.) Allen wrench.www.sxsevents.co.ukFiber optic cable 11
Page 1 and 2: andFiberSourcePhone: courtesy Audio
Page 3 and 4: and Phone: courtesy Audio-Visual 08
Page 5 and 6: To protect yourself and others from
Page 7 and 8: and Audio-Visual Servicesmail: www.
Page 9: and Audio-Visual Servicesmail: www.
Page 13 and 14: 3 Connect the output of the fixture
Page 15 and 16: CONTROLLABLE EFFECTSand Phone: cour
Page 17 and 18: Important! DIP-switch pin 10 must b
Page 19 and 20: and Audio-Visual Servicesmail: www.
Page 21 and 22: To replace the secondary fuse1 Disc
Page 23 and 24: Channel Value Percent Function120 -
Page 25 and 26: PHYSICALBand SPECIFICATIONS Phone:

FiberSource QFX 150 - SXS Events

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?