2. installation procedure for optional equipment - toshiba tec europe

More documents

Recommendations

Info

2. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-120102.1 Installing the Hard Disk Drive (HDD)2.1 Installing the Hard Disk Drive (HDD)CAUTION!1. For the specification of an HDD to be installed, please refer to the POS Optional Device (DocumentNo. EO21-12001), POS OPTIONAL DEVICE BASIC SPECIFICATION.2. Please use TOSHIBA TEC approved HDDs. Failure to do this may cause an error.Installation procedure for the first HDD is shown below.• Required PartsThe following part is required to install an HDD.HDD Unit (locally procured)HDD Fixing Screw M-3x3 (8 pcs.)(NOTE)NOTE:This is an accessory part of the POS terminal.• Installation Procedure1) Remove the two Rubber Caps from the Rear Cover.2) Remove the two screws then remove the Rear Cover.Rear CoverRubber CapRubber CapandDSM-4x10 Screw2- 2
2. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-120102.1 Installing the Hard Disk Drive (HDD)3) Let the HDD Cable off the HDD Holder.4) Remove the two screws, then remove the HDD Holder in the direction as indicated by the arrow.(Carefully remove the HDD Holder on which the two hooks are provided.)HookScrewM-3x3HDD CableHDD Holder5) Insert an HDD into the HDD Holder, then secure with the four HDD fixing screws. (The four out of eightpieces of option HDD fixing screws are used for an HDD.)HDD HolderHDDScrew M-3x36) Connect the HDD Connector to the HDD.2- 3
Page 1 and 2: TEC POS TerminalST-71 SERIESMainten
Page 3 and 4: EO18-12010(Revision Date: Jan. 30,
Page 5 and 6: 1. UNPACKING EO18-120101.1 Procedur
Page 7: 2. INSTALLATION PROCEDURE FOR OPTIO
Page 11 and 12: 2. INSTALLATION PROCEDURE FOR OPTIO

2. installation procedure for optional equipment - toshiba tec europe

Create successful ePaper yourself

Delete template?

Save as template?