2. installation procedure for optional equipment - toshiba tec europe

More documents

Recommendations

Info

2. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-120102.3 Installing the Line Display, Pole Unit, and VFD Stand10) Fit the Stopper onto the axis of the Pole.Stopper11) Hook the VFD Frame as shown in the figure, then secure it with the four screws.T-3x8 ScrewHookT-3x8 ScrewT-3x8 Screw12) Fully tighten the Pole Screw.Pole Screw2-16
2. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-120102.3 Installing the Line Display, Pole Unit, and VFD Stand13) Secure the VFD Base Frame onto the POS terminal with the four screws.DSM-4x12 ScrewVFD Base FrameDSM-4x12 Screw14) Lead the VFD Cable as shown in the figure, then secure the Rear Cover onto the POS terminal with the twoscrews.15) Hook the VFD Base Frame onto the VFD Frame at the three portions.HookVFD FrameVFD Base FrameRear CoverVFD Cable16) Secure the VFD Stand with the two screws.17) Attach the Rubber Caps onto the Rear Cover and the VFD Stand.VFD StandDSM-4x10 ScrewRubber CapRear Cover2-17
Page 1 and 2: TEC POS TerminalST-71 SERIESMainten
Page 3 and 4: EO18-12010(Revision Date: Jan. 30,
Page 5 and 6: 1. UNPACKING EO18-120101.1 Procedur
Page 7 and 8: 2. INSTALLATION PROCEDURE FOR OPTIO
Page 21: 2. INSTALLATION PROCEDURE FOR OPTIO

2. installation procedure for optional equipment - toshiba tec europe

Create successful ePaper yourself

Delete template?

Save as template?