2. installation procedure for optional equipment - toshiba tec europe

More documents

Recommendations

Info

2. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-120102.2 Installing the LVDS PC Board and Back Indicator Unit2) Remove the two screws which secure the Front Cover, then remove the Front Cover.ScrewFront CoverScrew3) Disconnect all cables from the ENGINE PC Board Assembly.ENGINE PC Board Assembly4) Downward slide and remove the Side Cover (L).Side Cover (L)2- 6
2. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-120102.2 Installing the LVDS PC Board and Back Indicator Unit5) Remove the two screws, then pull the Open Lever to draw the ENGINE PC Board Assembly.DSM-4x8 ScrewOpen LeverENGINE PC Board Assembly6) Remove the two Locking Supports, then remove the LVDS PC Board.LVDS PC BoardLocking Support7) Secure the option LVDS PC Board to the ENGINE PC Board Assembly with the two Locking Supports sothat the LVDS PC Board Guides surely fits the ENGINE PC Board Frame.Guide8) Return the ENGINE PC Board Assembly.9) Remove the Rear Cover. (Refer to Section 2.1 Installing the Hard Disk Drive (HDD).)LVDS PC Board2- 7
Page 1 and 2: TEC POS TerminalST-71 SERIESMainten
Page 3 and 4: EO18-12010(Revision Date: Jan. 30,
Page 5 and 6: 1. UNPACKING EO18-120101.1 Procedur
Page 7 and 8: 2. INSTALLATION PROCEDURE FOR OPTIO
Page 11: 2. INSTALLATION PROCEDURE FOR OPTIO

2. installation procedure for optional equipment - toshiba tec europe

Create successful ePaper yourself

Delete template?

Save as template?