Hubbell Wiring Device.pdf - Eversave Technology

Features and Benefits Pin and Sleeve DevicesIEC Pin and Sleeve“Reverse Service” Unfused Circuit-Lock ® Mechanical InterlocksFeatures and BenefitsLarge gears enclosed in agear box assembled on oneplane to eliminate possiblegear jumping.Watertight conduit huband grounding plate foruse on metallic conduit.Captured neoprenegasket for awatertight seal.Horsepower rateddisconnect switchhandles large motorloads.The National Electric Coderequires a separate disconnectmeans within sight of all motor loads.The NEC requires the disconnectingmeans in a motor-circuit be listed as“Suitable as Motor Disconnect” if themotor is rated greater than 2 HP.Hubbell’s “Reverse Service”Circuit-Lock ® Mechanical Interlockincorporates the disconnect switchand reverse service receptacle (inlet)in one compact non-metallic andeconomical unit.Color coded rating padand receptacle mount tosignify voltage.DIN rail mountedswitch for easyinstallation andreplacement.Hubbell Circuit-Lock ® Reverse Service Mechanical InterlocksLockable handle tomeet OSHA Lockout/Tagout regulations.Enclosure housing with brass insertsand stainless steel screws for highertorque and better sealing.At the same time, it eliminates thepossibility of making or breaking thecircuit under load or makinga casual or “lazy” connection.The switch cannot be turnedON until the reverse service plughas been inserted properly, andthe reverse service plug cannot beremoved until the switch is turnedOFF. The non-metallic enclosure canbe connected to metallic conduitand not interfere with theground continuity.Two-stage interlockingmechanism to helpdefeat tampering.Pre-wired IEC Pin andSleeve reverse servicereceptacle.Solid pins—dependablesolid brass for longerlife and reliableelectrical contact.Spring-loaded liftcoverwith gasket for awatertight seal.Adjustable mountingfeet are ductile toallow mounting onirregular surfaces.Three molded-in conduit drillpoints are located on top,bottom and back surface ofenclosure.These horsepower ratedunits are durable, watertightand easy to install and all “ReverseService” Circuit-Lock ® MechanicalInterlocks can be locked out as amethod of compliance with OSHALockout/Tagout regulation.These Circuit-Lock ® units areavailable in 30, 60 and 100A,4 wire configurations.IP67SUITABILITYE-20 www.hubbell-wiring.comDimensions in Inches (mm)