Manual HAHSON SR8 PLUS - VTP UP

More documents

Recommendations

Info

SR8-Plus Operation Manual73-100-810-IFigure 8-5: Motor Bottom Closure RemovalFigure 8-6: Belt Configuration and AdjustmentSection 8 Maintenance and Calibration – 61 –
SR8-Plus Operation Manual73-100-810-I8.12 Idler PulleysThe SR8-Plus has 6 idler pulleys, which should be checked when replacing belts for smoothrotation.To inspect the idler pulleys (use previous instructions in this section for more detail):1. Manually adjust the motor speed to 0.0RPM (stopped).2. Remove cover.3. Remove the 3 belts.4. Turn each of the idler pulleys indicated by hand to verify that each moves freely andsmoothly. If any of the idler pulleys do not rotate smoothly, remove grip ring, inspectbearings and shaft for wear. If bearings are dry, lubricate with grease. If you need help,contact your local service engineer or Hanson Research.5. Replace the belts.6. Replace cover.8.13 Fuse ReplacementThe fuses are located below the power switch on the right-hand side of the controller. Eachsystem has four fuses. The amperage is labeled next to the fuse. Notice that the amperageof the fuses is dependent upon the voltage of the system.NOTE: For continued protection against risk of fire, replace the fuse(s) with same type andcurrent rating. Do not over-tighten the fuse holder.To check the fuses and replace a defective fuse,1. For fuse holders with finger grip knobs, push in and slightly turn counter-clockwise toremove the holder.2. Visual inspection of the fuse is not conclusive; always use an ohm meter to confirm if afuse is defective.Section 8 Maintenance and Calibration – 62 –
Page 2 and 3:
SR8-Plus Operation Manual73-100-810
Page 4 and 5:
Page 6 and 7:
Page 8 and 9:
Page 10 and 11:
Page 12 and 13:
Page 14 and 15:
Page 16 and 17: SR8-Plus Operation Manual73-100-810
Page 72: SR8-Plus Operation Manual73-100-810
show all

Manual HAHSON SR8 PLUS - VTP UP

Create successful ePaper yourself

Delete template?

Save as template?