Manual HAHSON SR8 PLUS - VTP UP
Manual HAHSON SR8 PLUS - VTP UP
Manual HAHSON SR8 PLUS - VTP UP
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>SR8</strong>-Plus Operation <strong>Manual</strong>73-100-810-IFigure 8-4: Belt AdjustmentTo replace belts:1. <strong>Manual</strong>ly adjust the motor speed to 0.0RPM (stopped).2. Remove cover. (see Figure 8-3)3. Loosen the 3 idler pulleys and remove both the drive belts. (see Figure 8-4)4. Go to the back of the unit. Loosen the 4 screws that mount the motor bottom closure.Remove the closure by sliding it down and out. (see Figure 8-5)5. Reach under motor mount plate and loosen the 4 motor mounting screws.6. Slide motor forward and remove motor belt.7. Replace motor belt first and adjust. Then Replace drive belts and adjust. See Figure 8-6 for routing configuration.8. Replace cover.Section 8 Maintenance and Calibration – 60 –
Change language