Manual HAHSON SR8 PLUS - VTP UP

More documents

Recommendations

Info

SR8-Plus Operation Manual73-100-810-IFigure 8-3: Cover RemovalTo adjust the belts, see Figure 8-4:1. Program the motor speed to 0.0RPM (stopped) and turn power switch to the off position.2. Remove cover. (see Figure 8-3)3. For motor belt adjustment; loosen motor idler pulley and slide forward to tighten belt.Tighten idler pulley. Push against motor belt with a finger at point marked “A” to checkadjustment (belt should move from 2 to 5mm).4. For drive belt adjustment; loosen drive idler pulley and slide forward to tighten belt.Tighten idler pulley. Push against drive belt with a finger at point marked “B” to checkadjustment (belt should move from 6 to 10mm). Repeat for second drive belt.5. Replace cover.Section 8 Maintenance and Calibration – 59 –
SR8-Plus Operation Manual73-100-810-IFigure 8-4: Belt AdjustmentTo replace belts:1. Manually adjust the motor speed to 0.0RPM (stopped).2. Remove cover. (see Figure 8-3)3. Loosen the 3 idler pulleys and remove both the drive belts. (see Figure 8-4)4. Go to the back of the unit. Loosen the 4 screws that mount the motor bottom closure.Remove the closure by sliding it down and out. (see Figure 8-5)5. Reach under motor mount plate and loosen the 4 motor mounting screws.6. Slide motor forward and remove motor belt.7. Replace motor belt first and adjust. Then Replace drive belts and adjust. See Figure 8-6 for routing configuration.8. Replace cover.Section 8 Maintenance and Calibration – 60 –
Page 2 and 3:
SR8-Plus Operation Manual73-100-810
Page 4 and 5:
Page 6 and 7:
Page 8 and 9:
Page 10 and 11:
Page 12 and 13:
Page 14 and 15: SR8-Plus Operation Manual73-100-810
Page 72: SR8-Plus Operation Manual73-100-810
show all

Manual HAHSON SR8 PLUS - VTP UP

Create successful ePaper yourself

Delete template?

Save as template?