Manual HAHSON SR8 PLUS - VTP UP

SR8-Plus Operation Manual73-100-810-I1 Safety Considerations1.1 General1. The installation category (overvoltage category) for this instrument is Level II. The LevelII category pertains to equipment that receives its electrical power from a local level,such as an electrical wall outlet.2. This instrument must be connected to a grounded electrical outlet.3. Never work on the electrical components in the system while there is power to the unit.Disconnect power before servicing the instrument.4. Review all safety and environmental precautions pertaining to any chemicals that are tobe used in conjunction with this equipment.1.2 Safety MarkingsFor your own safety, you must observe the following safety warning markings. The safetywarning markings indicate a possible source of danger. At the same time they containinformation on how correct action can avert danger. You will always find safety warningmarkings attached to points of possible danger.Sign Location Safety WarningControlDanger! Supply voltage and supply frequency must be of thevalue specified for the control unit on the serial number taglocated on the rear panel of the SR8-Plus control. Allelectrical outlets must be properly grounded.ControlPrinterMotorHeaterCaution: No operator accessible parts inside. Refer servicingto qualified personnel only. Risk of electrical shock. Do notopen.Achtung: Es gibt keine vorn Benutzer zo wanenden Teile.Oberlassen Sie Reparaturen dem qualifizierten Servicefachmann.Hochspannung. Nicht öffnen.Attention: Aucune pièce remplaçable par l’utilisateur. Touteréparation doit être effectuée par un technicien qualifié.Risque d’ electrocution. Ne pas ouvrir.Precaución: No lo abra. Peligro de alto voltaje. El serviciodebe ser implementado por personal calificado.ControlCaution! Turn unit off and remove power cord beforereplacing fuses. Fuses must be replaced with the samecurrent rating and type described next to the fuse holder.Section 1 Safety Considerations – 1 –