Manual HAHSON SR8 PLUS - VTP UP

SR8-Plus Operation Manual73-100-810-I6.3 Vessel Temperature Log (no Digital Temperature Probes)The vessel temperature log is used to verify the accuracy of the temperature inside of thevessels. This validation is always performed with Temperature Probe 1. This procedure isnot required when the SR8-Plus is equipped with Digital Temperature Probes. To performthis function:1. With the Main screen displayed, press [PREFERENCES] to display the SystemOptions screen.2. Press [3] to select "Validation".3. Press [1] to display the “Vessel Temperature Log” screen.4. Use arrows to display the desired vessel. To log bath temperature use the arrow key tomove between the first and eighth vessel.5. Place Temperature Probe 1 into the indicated vessel or the bath. Watch the display untilthe temperature reading is stable, approximately 20 to 30 seconds.6. Press [PRINT OPTIONS]. The date, time, vessel number and the actual vesseltemperature is printed.7. Repeat Step 6 for each of the vessels and the bath.6.4 Starting and Running a Test (with Digital Temperature Probes and E-Probes)NOTE: See Section 5 for programming and operational capabilities.1. Press [RUN] on the SR8-Plus and select a pre-programmed protocol and press[ENTER]. If the SR8-Plus is connected to an AutoPlus, the AutoPlus will start the sameprotocol number as the SR8-Plus(s) automatically.2. If USP tolerance is on, the E-Probes will lower allowing the Digital Temperature Probesto verify that the vessel temperature is within the required operating temperature. TheDigital Temperature Probes will stay in this position until that requirement is met or thetest is aborted.3. When all parameters are ready, the probes will raise and the screen will say “drop doseand press run”.4. Drop the dosage or lower baskets and press [RUN] to start the test. At the start of thetest the Digital Temperature Probes will be lowered by the E-Probes and print thestarting temperature.5. Cover vessels.Section 6 Running A Test – 48 –