Manual HAHSON SR8 PLUS - VTP UP

SR8-Plus Operation Manual73-100-810-IPress[RUN].If Auto Print was selected, the status conditions are printed at the interval specified in theprotocol.The number of samples, and the remaining time until the next sampling, is displayed on theStatus screen. If the sampling alarm is turned on, when each sampling interval is reached,an audible alarm will sound, a warning window will display momentarily, and the "Timer Alert"will illuminate.When the test is complete, the system checks for an infinity test. If an infinity test is selectedin the protocol, the infinity test is performed.When the protocol is complete, the drive motor is stopped automatically. Temperature controlremains on, unless "Heater Shutdown" was selected in the System Configuration Menu.5.25 Starting the Manual Timer1. Press [SET TEMPERATURE], and input the desired temperature. Wait untilvessel temperature is within the required tolerance of the set temperature.2. Press [SET SPEED], and input the desired drive speed. This step may bedelayed until the start of the timer, if so desired.3. When ready to start the manual test, press [CLOCK].4. Select option [6] “Start Timer”, and the Manual Timer Setup Screen appears.5. Select an automatic print interval. Either OFF, 5, 15, 30, or 60 minutes can be selected.Make sure that the printer is on-line and has enough paper.6. When ready to start the timer, press [CLOCK]. The test will run uninterrupted.7. Press [STOP] to reset the manual timer and stop the test.Section 5 Operation and Programming – 43 –