Manual HAHSON SR8 PLUS - VTP UP

SR8-Plus Operation Manual73-100-810-ICalibration AlarmThe calibration alarm is used to alert the user when the calibration must be done to validatethe system. To set the calibration alarm:1. With the Main screen displayed, press [CLOCK] to display the SystemAlarm/Timers screen.2. Press [4] to select "Calibration Alarm". The Calibration Alarm screen is displayed.3. Input the date, time and recurrence for the next calibration. Follow each input with[ENTER].When the date and time are reached, the user is alerted of the alarm by an audible sound, apop-up window on the screen, and illumination of the "Timer Alert" status light on the display.Canceling an AlarmAn alarm that has been set, but has not become due, can be canceled by displaying the inputscreen and pressing [CLR].Acknowledging an AlarmWhen an alarm is triggered, the "Timer Alert" status light is illuminated and a warning windowis displayed momentarily. The window is displayed again every few seconds and the audiblebeep is sounded until the alarm is acknowledged. To acknowledge the alarm:1. Press [CLOCK]. The alarm pop-up window is displayed one last time.2. Press any key to acknowledge the alarm and turn the "Timer Alert" light off.3. Press [ESC] to return to the Main screen.NOTE: This does not apply to Sampling Alarms.Section 5 Operation and Programming – 37 –