Manual HAHSON SR8 PLUS - VTP UP

SR8-Plus Operation Manual73-100-810-I5.8 Print Options __________________________________________________________ 295.9 System Options ________________________________________________________ 305.10 Adjusting the Contrast _________________________________________________ 305.11 Heater Shutdown_______________________________________________________ 305.12 Validation _____________________________________________________________ 305.13 Calibration_____________________________________________________________ 315.14 Security _______________________________________________________________ 315.15 Adding, Changing or Removing Users ___________________________________ 325.16 Diagnostics____________________________________________________________ 325.17 System Configuration Parameters _______________________________________ 325.18 Timer / Alarm Operation ________________________________________________ 355.19 Selecting Creating and Viewing Protocol Parameters _____________________ 385.20 Entering Protocol Parameters ___________________________________________ 385.21 Editing a Protocol ______________________________________________________ 405.22 Viewing Protocol Parameters ___________________________________________ 405.23 Running A Test ________________________________________________________ 405.24 Starting a Protocol _____________________________________________________ 415.25 Starting the Manual Timer ______________________________________________ 435.26 System Shutdown and Start Up _________________________________________ 445.27 Stand By Mode_________________________________________________________ 445.28 Serial Number Log _____________________________________________________ 455.29 Software Flow Chart____________________________________________________ 466 Running A Test_________________________________________________476.1 Setting Up _____________________________________________________________ 476.2 Starting and Running a Test (no Digital Temperature Probes) _____________ 476.3 Vessel Temperature Log (no Digital Temperature Probes) _________________ 486.4 Starting and Running a Test (with Digital Temperature Probes / E-Probes)__ 486.5 During the Test ________________________________________________________ 496.6 After the Test __________________________________________________________ 497 Troubleshooting ________________________________________________507.1 Contacting Hanson Research Corporation for Technical Support __________ 507.2 Troubleshooting Table _________________________________________________ 507.3 Diagnostic Tests _______________________________________________________ 52Table of Contentsii