Manual HAHSON SR8 PLUS - VTP UP

More documents

Recommendations

Info

SR8-Plus Operation Manual73-100-810-I5. Press the up arrow to return the sampling probes to the home position.NOTE: The probe will only move if a stroke value has been entered into the protocol. Alwaysset the stroke to 45mm unless there is a requirement to stroke a different amount.4.14 Adjusting Digital Temperature ProbesThe tip of the Digital Temperature Probes should be adjusted to the tip of the sampling probeor its filter.To adjust Digital Temperature Probes:1. Make sure that the E-Probes are at the top of their stroke. If you are not sure, homeprobes. (see Section 5.17--System Configuration Parameters: E-Probe Setup)2. Have the SR8-Plus mechanical settings adjusted and ready to start the test.3. The Digital Temperature Probe is designed to clip onto the sampling probe. Move theDigital Temperature Probes up or down so that the tip of the Digital Temperature Probeis at the same level as the tip of the sampling probe or sampling filter.Section 4 Installation – 23 –
SR8-Plus Operation Manual73-100-810-I5.1 Keypad DescriptionKey Key Name Use5 Operation and ProgrammingRunSpeedThe first press of this key allows the user to select a storedprotocol. The second press of this key starts the selectedprotocol.This key allows the user to manually set the speed. Thiskey is not functional when a protocol is running.TemperatureEdit/View ProtocolPreferencesPrint OptionsThis key allows the user to manually set the temperatureand to view the Digital Temperature Probe screen (whenDigital Temperature Probes are installed).This key is used to select the parameters for a new protocol.This key is also used to edit/view the parameters of a storedprotocol. A password may be required to changeparameters.This key is used to access a series of options that aresecondary to the normal operation of the system. Theseinclude: contrast adjustment for the LCD display, heatershutdown option at the end of a test, validation andcalibration options, security and user options, diagnostics,and system configuration.This key is used to access print options. These include:print status, print protocol, print header and print last test.StopThis key is used to abort a test in progress. Press twice toabort test. If this key is pressed when there is no test inprogress, the system is placed in the standby mode.ClockHelpThis key is used to access the clock and alarm options.These include: clock options, preheat wakeup alarm,sampling alarm, user alarms, calibration alarm, alarmacknowledgment and start manual timer. This key is alsoused to access revision information when available.This key is used to access the help screens for the system.Section 5 Operation and Programming – 24 –
Page 2 and 3: SR8-Plus Operation Manual73-100-810
Page 72: SR8-Plus Operation Manual73-100-810

Manual HAHSON SR8 PLUS - VTP UP

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?