Manual HAHSON SR8 PLUS - VTP UP

More documents

Recommendations

Info

SR8-Plus Operation Manual73-100-810-IFigure 4-12: Circulating Water Pump Connection12. Install the temperature probes(s). (see Figure 4-13)NOTE: The system is designed to operate with either one or two temperature probes. One issupplied with the system, the other is optional. Probe 1 is designed to be placed inthe bath. Probe 2 can be placed in Vessel 7 or 8 if they are not used for testing, or atthe opposite end of the bath.a) Plug the temperature probe(s) into the connector(s) labeled “TEMP PROBES” onthe left hand side of the SR8-Plus Controller. The first probe must be plugged intoconnector “1”, and the optional second probe must be plugged into connector “2”.b) For Probe 1, route the cable around the side of the bath and place the temperatureprobe into the bath, using one of the two holes indicated in Figure 13. Push thetemperature probe into the bath as far as it will go.c) For Probe 2, route the cable behind the bath and place the temperature probe intoeither Vessel 7 or 8. Secure the probe so that it remains in the vessel.Section 4 Installation – 17 –
SR8-Plus Operation Manual73-100-810-IFigure 4-13: Temperature Probe Installation4.8 Printer InstallationThe printer may be installed in one of two configurations: Standard or Daisy-chained.Standard is the more common configuration where each SR8-Plus installed is connected toits own printer. In the Daisy-chained configuration, several SR8-Plus Dissolution TestStations are connected to a single printer.NOTE: Refer to the operating instructions provided with the printer for information on paperand ribbon installation.Standard Configuration1. Plug the printer into the power outlet labeled “PRINTER” on the right hand side of theSR8-Plus Controller.NOTE: The printer is 115V and must be plugged into the printer power outlet on the SR8-Plus Controller. The printer should be placed away from the test area to keep it frombeing damaged by liquid.2. Plug the cable connected to the printer into the port connector labeled “COMM PORT 3”on the left hand side of the SR8-Plus Controller.Section 4 Installation – 18 –
Page 2 and 3: SR8-Plus Operation Manual73-100-810
Page 72:
SR8-Plus Operation Manual73-100-810
show all

Manual HAHSON SR8 PLUS - VTP UP

Create successful ePaper yourself

Delete template?

Save as template?