Manual HAHSON SR8 PLUS - VTP UP

SR8-Plus Operation Manual73-100-810-IFigure 4-11: Positioning the Vessels10. Use DI (or better) water to fill the bath to the desired level. (This level is usually at leastto the 900 mL mark on the vessels.)11. Install the Circulating Water Pump. (see Figure 4-12)a) Install the circulating water pump into the bath through the Vessel #1 hole. Place itas low in the bath as possible without the case of the pump touching the bath wall.b) Center the circulating water pump between Vessels 1 & 2 and press the pump’s feetto the inside of the bath wall. The outlet of the pump should be pointing towards theheater and the power cord should be pointing up.c) Pull the bath out away from the dissolution station enough to where the end of thepower cord can be routed out and over the top back portion of the bath. Whenfinished, the cord should be coming out over the back right corner of the bath withinthe groove.d) Make sure the power cord is not in anyway pinched or pressed by the bath or theframe.e) Plug the circulating water pump into the power outlet labeled “AIR PUMP” on theright hand side of the SR8-Plus Controller.f) The only maintenance for the circulating water pump is to ensure that the waterbathis reasonably clean.NOTE: The circulating water pump is 115V and must be plugged into the “AIR PUMP” poweroutlet on the SR8-Plus Controller.Section 4 Installation – 16 –