Manual HAHSON SR8 PLUS - VTP UP

SR8-Plus Operation Manual73-100-810-I4. Notice that there are a series of connectors on the right-hand side of the SR8-Pluscontroller. (see Figure 4-6)a) Connect ground strap to ground connector.b) Plug the motor cable into the connector labeled “MOTOR”. Make sure to line up thekeyways in the plug with the slot in the socket, push plug in and then turn the ring onthe plug to secure.c) Plug the user interface cable into the connector labeled “DRIVE”. Evenly tighten thescrews that secure the plug to the controller.NOTE: If the E-Probe has been supplied with the system, the E-Probe power cord is thesmaller of the two power cords supplied. Do not switch these two power cords;always use the heavier main power cord for the control.d) Connect the power cord into the connector labeled “AC-INPUT”.5. Secure the SR8-Plus Controller to the Easi-Lift Frame by pulling the “S-Hook” andinserting it into the metal loop in the frame. (see Figure 4-7)Figure 4-7: Securing the SR8-Plus ControllerSection 4 Installation – 12 –