Manual HAHSON SR8 PLUS - VTP UP

More documents

Recommendations

Info

SR8-Plus Operation Manual73-100-810-IFigure 4-5: Raising the Drive Head2. Lower and raise the drive head to verify that it moves smoothly over the full range ofmotion. Position the drive head at its highest location. Release lever to activate thebrake.3. Position the SR8-Plus Controller on the back rail of the basic system assembly. (seeFigure 4-6)Figure 4-6: Positioning the ControllerSection 4 Installation – 11 –
SR8-Plus Operation Manual73-100-810-I4. Notice that there are a series of connectors on the right-hand side of the SR8-Pluscontroller. (see Figure 4-6)a) Connect ground strap to ground connector.b) Plug the motor cable into the connector labeled “MOTOR”. Make sure to line up thekeyways in the plug with the slot in the socket, push plug in and then turn the ring onthe plug to secure.c) Plug the user interface cable into the connector labeled “DRIVE”. Evenly tighten thescrews that secure the plug to the controller.NOTE: If the E-Probe has been supplied with the system, the E-Probe power cord is thesmaller of the two power cords supplied. Do not switch these two power cords;always use the heavier main power cord for the control.d) Connect the power cord into the connector labeled “AC-INPUT”.5. Secure the SR8-Plus Controller to the Easi-Lift Frame by pulling the “S-Hook” andinserting it into the metal loop in the frame. (see Figure 4-7)Figure 4-7: Securing the SR8-Plus ControllerSection 4 Installation – 12 –
Page 2 and 3: SR8-Plus Operation Manual73-100-810
Page 66 and 67:
SR8-Plus Operation Manual73-100-810
Page 68 and 69:
Page 70 and 71:
Page 72:
show all

Manual HAHSON SR8 PLUS - VTP UP

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?