Manual HAHSON SR8 PLUS - VTP UP

More documents

Recommendations

Info

SR8-Plus Operation Manual73-100-810-I4.3 Identification1. Bath Support2. SR8-Plus Controller3. Circulating Water Pump4. Power Cord5. Waterbath6. Vessel Centering Rings7. Vessels8. Drain Hose9. SR8-Plus Easi-Lift FrameFigure 4-2: System PartsOpen End WrenchHex WrenchPaddle Spacer(with Paddle order)Basket Spacer(with Basket order)Figure 4-3: Supply KitSection 4 Installation – 9 –
SR8-Plus Operation Manual73-100-810-IPaddlePrinterBasket & Basket ShaftFigure 4-4: Accessories4.4 Installation StepsCaution: Unit should not be plugged in until installed as per instructions below.Achtung: Das Gerät darf nicht an das Netz angeschlossen werden, bevor es nicht nach denuntenstehenden Instruktionen installiert worden ist.Attention: Ne pas brancher l’appareil avant installation complète comme démontrécidessous.Precaución: La unidad no debe ser conectada al toma corriente hasta que sea instalada deacuerdo a las instrucciones descritas abajo.1. Raise the drive head by holding in the lever with the left hand, while pushing up on thehandle. (see Figure 4-5)Section 4 Installation – 10 –
Page 2 and 3: SR8-Plus Operation Manual73-100-810
Page 64 and 65:
SR8-Plus Operation Manual73-100-810
Page 66 and 67:
Page 68 and 69:
Page 70 and 71:
Page 72:
show all

Manual HAHSON SR8 PLUS - VTP UP

Create successful ePaper yourself

Delete template?

Save as template?