12.07.2015 Views

Installation and Commissioning

Installation and Commissioning

Installation and Commissioning

SHOW MORE
SHOW LESS
  • No tags were found...

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

MaintenanceThe benefit with a lithium battery is the lifetime, which can be up to 5 years in service,compare with the Ni-Cd battery’s max life time of 3 years in service.Two lithium batteries exists:- a 3-cell battery, art.no. 3HAB 9999-1- a 6-cell battery, art.no. 3HAB 9999-2The life time of the lithium battery depends on how frequently the user switches off thepower. The estimated max life time in years for the different lithium batteries <strong>and</strong> therecommended exchange interval is shown below:User type: Exchange 3-cell: Exchange 6-cell:1. Vacation (4 weeks) power off every 5 years every 5 years*2. Weekend power off + user type 1 every 2 years every 4 years3. Nightly power off + user type 1 <strong>and</strong> 2 every year every 2 years* Because of material ageing the maximum life time in service is 5 years.Voltage of batteries, measured at power off:MinMax.Ni-Cd 7.0 V 8.7 VLithium 7.0 V -Exchange of the battery is done according to the first section of this chapter.2.5 Changing filters/vacuum cleaning the drive-system coolingThe article number of the filter is 3HAB 8028-1.• Loosen the filter holder on the outside of the door by moving the holder upwards.• Remove the old filter <strong>and</strong> install a new one (or clean the old one <strong>and</strong> re-install it).• When cleaning, the rough surface (on the clean-air side) should be turned inwards.Clean the filter three or four times in 30-40° water with washing-up liquid or detergent.The filter must not be wrung out, but should be allowed to dry on a flat surface.Alternatively, the filter can be blown clean with compressed air from the clean-airside.• If an air filter is not used, the entire cooling duct must be vacuum cleaned regularly.2.6 Checking the mechanical stop, axis 1Check regularly, as follows:Stop pin:- that the pin is not bent.If the stop pin is bent, it must be replaced by a new one. See chapter 13, section 2.4.The article number of the pin is 3HAB 3258-1.6 Product Manual IRB 1400

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!