FLAT-TO-WALL LCD TV MOUNT - Philex

FLAT-TO-WALL LCD TV MOUNTPart No. 28071RInstallation InstructionsWARNING!!!!Correct assembly is essentialThis mount should be fitted to solid wood, brick or concrete wallNote: We have not supplied wall fixings with this product. All walls differ in strength andthickness. We advise that you consult professional personell for guidance for purchasingscrews designed specifically for your type of wall.M5 x 10M4 x 10COMPATIBILITY CHECKERThis TV bracket is designed to fit LCD TV’s and computer monitors with VESA 50, VESA 75, VESA100 and VESA 200x100 bracket fittings. These standard fittings are found on almost all systemsalthough some may vary - in which case you may need to contact the TV manufacturer for assistance.To check if your TV or monitor is compliant,look at the back of your systemand check it has four mounting holesspaced in any of the combinationsshown.VESA 50Fittings75MMVESA 75Fittings75MM75MM75MMVESA 100FittingsVESA 200 x 100 Fittings100MM100MM100MM100MMturn over for installation instructions...

WALLSTEP ONE - Preparing the wall fittingsMark and drill four holes in your wall to allow mounting of the bracket at the four holes marked on the diagram below.Fit wall screws to your wall according to the wall structure (seek professional advise before attempting to install) leaving2-3mm gap between the screw head and the wall surface. This allows the plate to slide onto the screws.WALLVESA 50/75/100 TYPE FITTINGSWALLVESA 200 x 100 TYPE FITTINGBACK OF TELEVISIONSTEP TWO - Fitting to the televisionWALLOnce you have checked the compatibility of your television, locate the fitting holes on the mounting plate that match yourtelevisions mounting holes. See black fitting holes marked on the diagram below.Check which type of the supplied fitting screws fit your television (M4 or M5) and attach the plate firmly to the back ofyour television.VESA 50/75/100 TYPE FITTINGSBACK OF TELEVISIONVESA 200 x 100 TYPE FITTINGBACK OF TELEVISIONSTEP THREE- Fitting to the wallBACK OF TELEVISIONNow that the mount is securely fastened to the television, lift the television onto the wall screws using the keyhole wallfitting holes shown in STEP ONE.If the television feels loose on the wall, lift the mount off the wall screws and tighten them to decrease the gap betweenthe screw head and wall.Customer Careline: 0901 293 0038Calls are charged at £1 per minute from a BT landline. Call charges from other networks may varySupport: http://technical.philex.comv2