RS-1000 Manual - kamery airlive airlivecam
RS-1000 Manual - kamery airlive airlivecam RS-1000 Manual - kamery airlive airlivecam
Step 9. Open all the services (ANY). The setup is completed.187
Install a server inside the LAN network, open to all the IP addresses including LAN and WANIPs to use QoS to attain the maximum downstream and upstream bandwidth. The setuporders should be QoS, Virtual Server and then Policy.Step 1. Enter the QoS window in the menu bar on the left hand side of the window.Step 2. Click the New Entry button.Step 3. In the Add New QoS window, enter each parameter.Step 4. Click OK.Step 5. When the following screen appears, the QoS setup is completed.Step 6. Go to the Virtual server 1 window under the Virtual server menu.Step 7.Click the Click here to configure button.188
- Page 141 and 142: Downloading the Traffic LogsThe Adm
- Page 143 and 144: Event LogWhen the Security Bandwidt
- Page 145 and 146: Clearing the Event LogsThe Administ
- Page 147 and 148: Download LogsStep 1. Click Log in t
- Page 149 and 150: Log BackupStep 1. Click Log $Log Ba
- Page 151 and 152: Disable Log Mail Support & Syslog M
- Page 153 and 154: Traffic AlarmIn control policies, t
- Page 155 and 156: Clearing the Traffic Alarm LogsStep
- Page 157 and 158: Downloading the Event Alarm LogsThe
- Page 159 and 160: Accounting ReportAccounting Report
- Page 161 and 162: Outbound Accounting ReportStep 1. C
- Page 163 and 164: Outbound Destination IP Accounting
- Page 165 and 166: Outbound Service Accounting ReportS
- Page 167 and 168: InboundStep 1. Click Service in the
- Page 169 and 170: Inbound Destination IP Accounting R
- Page 171 and 172: Inbound Service Accounting ReportSe
- Page 173 and 174: StatisticsIn this chapter, the Admi
- Page 175 and 176: WAN StatisticsStep 1. Click Statist
- Page 177 and 178: Entering the Policy SatisticsStep 1
- Page 179 and 180: Interface StatusEntering the Interf
- Page 181 and 182: ARP TableEntering the ARP Table win
- Page 183 and 184: Setup ExamplesExample 1: Allow the
- Page 185 and 186: 180
- Page 187 and 188: Step 8. Go to the Incoming window u
- Page 189 and 190: Step 6. In the Add New Policy windo
- Page 191: Step 7. Click the New Entry button.
- Page 195 and 196: Step 9. After adding new server IP,
- Page 197: Step 14. In the Add New Policy wind
Step 9. Open all the services (ANY). The setup is completed.187