About Omneon MediaGrid - Harmonic Inc

System Installation with ContentServer 3000 Series
Rack Mounting the MediaGrid System with ContentServer 3000
The following steps provide an overview of installing each of the Omneon MediaGrid 3.0
components. A rack mounting kit is provided with each device, which includes the necessary hardware
along with detailed mounting instructions. For more complete mounting instructions, follow the rack
installation instructions provided with each Omneon MediaGrid component.
NOTE: Each device should be placed on the rack and then secured to the rails before mounting the next
device.
To rack mount a MediaGrid system with the ContentServer 3000:
1. Unpack the Omneon MediaGrid storage system components. Start at the bottom of the rack with a
ContentServer if this is the first device you are mounting.
2. Unpack the rack mount kit, which includes assorted mounting hardware, rear and side mounting
brackets, adapters for round hole racks, and printed instructions. For each device, always follow the
instructions in the mounting kit and use the screws that are included with the mounting
hardware.
3. Install the inner rack rails as follows:
a. Extend the inner rail toward the front of the rail assembly as far as possible, then depress the
locking tab to pull it completely out.
b. Place the inner rail on the side of the chassis aligning the hooks of the chassis with the rail
extension holes.
c. Slide the extension toward the front of the chassis.
d. Secure the chassis to the rails with screws.
e. Repeat steps 1-3 for the other inner rail.
Figure 4. Installing the inner rack rails
26 Installation and Configuration Guide