About Omneon MediaGrid - Harmonic Inc

Legacy Hardware Platforms
Figure 142 and Table 76 describe the rear panel view of the ContentBridge 2010A.
Figure 142. Rear View of ContentBridge 2010A
Table 76. ContentBridge 2010A Rear Panel Descriptions
Indicator, Button, or
Connector Description
1. 10GbE port Use to connect the ContentBridge to the customer network switch.
The Link light does not appear until the Configuration Assistant is
completed for the ContentBridge. Refer to About Omneon
MediaGrid Configuration for more information.
2. Serial connector Use to connect a serial device to the system.
3. Video connector Use to connect a monitor to the system.
4. USB connectors (2) Use to connect USB devices to the system.
5. Gigabit Ethernet ports
(2)
6. System status indicator
connector
7. System identification
button
Unused.
For service personnel use only.
Both the SystemManager application and the identification buttons
on the front and back panels can be used to locate a particular system
within a rack. When one of these buttons is pressed, the LCD display
on the front of the device and the blue system status indicator on the
back blink until one of the buttons is pressed again.
8. System status indicator Blinks when the front or back system identification button is
pressed.
9. Power supply (2) Dual, redundant power supplies provide power to the system.
284 Installation and Configuration Guide