About Omneon MediaGrid - Harmonic Inc
About Omneon MediaGrid - Harmonic Inc About Omneon MediaGrid - Harmonic Inc
Hardware Reference Left Control Panel Figure 122. ContentStore 3160 Control Panel LEDs Table 55. ContentStore 3160 Front Bezel LEDs 15 OPEN Symbol LED Color/State Description 1 2 3 Right Control Panel 1 Power Solid Indicates that power is being supplied to the power supply units 2 SAS-Out Solid Indicates that the SAS output port is connected. 3 Power Fail Solid Indicates a power supply module has failed. Refer to the Omneon MediaGrid Component Replacement Guide for details on replacing the power supply. 4 Heartbeat Flashing Indicates that power is being supplied to the server board 250 Installation and Configuration Guide 4 5 6 0 OPEN
Table 55. ContentStore 3160 Front Bezel LEDs Symbol LED Color/State Description Disk Drive Status LEDs Hardware Reference 5 SAS-In Solid Indicates that the SAS input port is connected. 6 Overheat/ Fan Fail Flashing Indicates fan failure Refer to Figure 123 and Table 56 for information on the Disk Drive Status LEDs. Refer to the Omneon MediaGrid Component Replacement Guide for instructions on replacing a failed drive. 0 OPEN LEDs Figure 123. Disk Drive Status LEDs Solid Overheat condition, which may be caused by cables obstructing the airflow in the system or the ambient room temperature being too warm. Check the routing of the cables and make sure all fans are present and operating normally. You should also check to make sure that the chassis covers are installed. Finally, verify that the heats inks are installed properly Omneon, Now Part of Harmonic 251
- Page 223 and 224: Power, fault and locator LEDs Conso
- Page 225 and 226: Power and fault LEDs Figure 75. Rea
- Page 227 and 228: Table 8. ContentDirector Indicator
- Page 229 and 230: Drive-status Indicator Pattern Cond
- Page 231 and 232: Indicator Pattern Condition Content
- Page 233 and 234: Off White Blue Red Ethernet Port 0
- Page 235 and 236: Link indicator Port 0 Port 1 Figure
- Page 237 and 238: Yellow Power on White Red Ethernet
- Page 239 and 240: Table 21. Drive-status Indicator Pa
- Page 241 and 242: Power Supply LEDs Figure 93 and Tab
- Page 243 and 244: Table 26. ContentServer 1042 Ethern
- Page 245 and 246: Table 29. ContentServer 1042B Rear
- Page 247 and 248: Figure 99. Rear View of ContentServ
- Page 249 and 250: 1 PWR RST MediaGrid Figure 101. Con
- Page 251 and 252: Table 34. ContentServer 2122 Front
- Page 253 and 254: 2 1 2 1 3 ID Figure 104. ContentSer
- Page 255 and 256: Front Panel Components Front Bezel
- Page 257 and 258: Table 39. ContentServer 2124 Front
- Page 259 and 260: 2 1 2 1 3 ID Figure 109. ContentSer
- Page 261 and 262: ContentServer 3000 Hardware Referen
- Page 263 and 264: Left Control Panel Figure 113. Cont
- Page 265 and 266: Table 46. Disk Drive Status LEDs LE
- Page 267 and 268: Table 47. ContentServer 3000 Rear P
- Page 269 and 270: Figure 117. NVRAM Card LEDs 2 1 3 T
- Page 271 and 272: Figure 119. 10 Gigabit Ethernet Add
- Page 273: 1 Drive 15 15 OPEN 14 Figure 121. C
- Page 277 and 278: Table 57. ContentStore 3160 Rear Pa
- Page 279 and 280: CHAPTER 8 Troubleshooting This sect
- Page 281 and 282: Troubleshooting The dhcp-leases fil
- Page 283 and 284: Troubleshooting The two most import
- Page 285 and 286: Troubleshooting points. The number
- Page 287 and 288: Security with Microsoft Domain Cont
- Page 289 and 290: mdsclientn dialog output: Troublesh
- Page 291 and 292: sessions output: *** 1/64 RPC sessi
- Page 293 and 294: APPENDIX A Legacy Hardware Platform
- Page 295 and 296: Figure 127. ContentDirector Hard Dr
- Page 297 and 298: . Figure 129. ContentDirector Power
- Page 299 and 300: Table 65. ContentDirector Indicator
- Page 301 and 302: Drive-status Indicator Pattern Cond
- Page 303 and 304: 1. Link indicator 2. Activity indic
- Page 305 and 306: Figure 139 and Table 72 describe th
- Page 307 and 308: Figure 141. ContentBridge Front Pan
- Page 309 and 310: Table 77. ContentBridge 2010A Ether
- Page 311 and 312: Figure 145. ContentServer 1242 with
- Page 313 and 314: Table 81. ContentServer 1242 Ethern
Table 55. ContentStore 3160 Front Bezel LEDs<br />
Symbol LED Color/State Description<br />
Disk Drive Status LEDs<br />
Hardware Reference<br />
5 SAS-In Solid Indicates that the SAS input port is connected.<br />
6 Overheat/ Fan Fail Flashing Indicates fan failure<br />
Refer to Figure 123 and Table 56 for information on the Disk Drive Status LEDs. Refer to the<br />
<strong>Omneon</strong> <strong>MediaGrid</strong> Component Replacement Guide for instructions on replacing a failed drive.<br />
0<br />
OPEN LEDs<br />
Figure 123. Disk Drive Status LEDs<br />
Solid Overheat condition, which may be caused by<br />
cables obstructing the airflow in the system or<br />
the ambient room temperature being too<br />
warm. Check the routing of the cables and<br />
make sure all fans are present and operating<br />
normally. You should also check to make sure<br />
that the chassis covers are installed. Finally,<br />
verify that the heats inks are installed properly<br />
<strong>Omneon</strong>, Now Part of <strong>Harmonic</strong> 251
Change language