About Omneon MediaGrid - Harmonic Inc
About Omneon MediaGrid - Harmonic Inc About Omneon MediaGrid - Harmonic Inc
Hardware Reference Figure 107. ContentServer 2124 Front Bezel LEDs Table 39. ContentServer 2124 Front Bezel LEDs # LED Color/State Description a Ethernet interface port 0 and 2 b Ethernet interface port 1 and 3 ContentServer 2124 White (solid) (blink) Indicates NIC is online. Normal state, network activity. Blue (blink) Indicates that the ContentServer cannot download its configuration file from the ContentDirector. The possible reasons include the following: • No IP address from ContentDirector • Cannot find the tftp server on ContentDirector • Unable to contact ContentDirector Refer to Verifying DHCP Settings to check DHCP status. Red Indicates that the Ethernet interface is offline. The possible reasons include the following: • There is no connection • The connection may be down • The connector may need replacing White (solid) (blink) Indicates that NIC is online. Normal state, network activity. Blue (blink) Indicates that the ContentServer cannot download its configuration file from the ContentDirector. The possible reasons include the following: • No IP address from ContentDirector • Cannot find the tftp server on ContentDirector • Unable to contact ContentDirector Refer to Verifying DHCP Settings to check DHCP status. 232 Installation and Configuration Guide a c e b d f
Table 39. ContentServer 2124 Front Bezel LEDs (Continued) # LED Color/State Description c. Disk 1, 5, 9 d. Disk 2, 6, 10 e. Disk State 3, 7, 11 f. Disk State 4, 8, 12 Front Panel View Hardware Reference Red Indicates that the Ethernet interface is offline. The possible reasons include the following: • There is no connection • The connection may be down • The connector may need replacing White (solid) Normal state, disk online. White (blink) LED blinks during any read or write activity on disk. Red Disk is offline. It may be unmounted or it is inactive Figure 108 and Table 40 detail the front view of the ContentServer 2124 with the front bezel removed and all disk drives in place. The circled numbers on the figure identify the drive slot numbers. Omneon, Now Part of Harmonic 233
- Page 205 and 206: Figure 60. Firmware Version Selecti
- Page 207 and 208: Administrative Procedures Use the f
- Page 209 and 210: Administrative Procedures 1. From t
- Page 211 and 212: To log on to a ContentDirector: 1.
- Page 213 and 214: 3. Type the following two lines at
- Page 215 and 216: Administrative Procedures 1. Attach
- Page 217 and 218: 4. Change directory to /mnt, as sho
- Page 219 and 220: CHAPTER 7 Hardware Reference This c
- Page 221 and 222: Figure 67. Rear View of 1010 Networ
- Page 223 and 224: Power, fault and locator LEDs Conso
- Page 225 and 226: Power and fault LEDs Figure 75. Rea
- Page 227 and 228: Table 8. ContentDirector Indicator
- Page 229 and 230: Drive-status Indicator Pattern Cond
- Page 231 and 232: Indicator Pattern Condition Content
- Page 233 and 234: Off White Blue Red Ethernet Port 0
- Page 235 and 236: Link indicator Port 0 Port 1 Figure
- Page 237 and 238: Yellow Power on White Red Ethernet
- Page 239 and 240: Table 21. Drive-status Indicator Pa
- Page 241 and 242: Power Supply LEDs Figure 93 and Tab
- Page 243 and 244: Table 26. ContentServer 1042 Ethern
- Page 245 and 246: Table 29. ContentServer 1042B Rear
- Page 247 and 248: Figure 99. Rear View of ContentServ
- Page 249 and 250: 1 PWR RST MediaGrid Figure 101. Con
- Page 251 and 252: Table 34. ContentServer 2122 Front
- Page 253 and 254: 2 1 2 1 3 ID Figure 104. ContentSer
- Page 255: Front Panel Components Front Bezel
- Page 259 and 260: 2 1 2 1 3 ID Figure 109. ContentSer
- Page 261 and 262: ContentServer 3000 Hardware Referen
- Page 263 and 264: Left Control Panel Figure 113. Cont
- Page 265 and 266: Table 46. Disk Drive Status LEDs LE
- Page 267 and 268: Table 47. ContentServer 3000 Rear P
- Page 269 and 270: Figure 117. NVRAM Card LEDs 2 1 3 T
- Page 271 and 272: Figure 119. 10 Gigabit Ethernet Add
- Page 273 and 274: 1 Drive 15 15 OPEN 14 Figure 121. C
- Page 275 and 276: Table 55. ContentStore 3160 Front B
- Page 277 and 278: Table 57. ContentStore 3160 Rear Pa
- Page 279 and 280: CHAPTER 8 Troubleshooting This sect
- Page 281 and 282: Troubleshooting The dhcp-leases fil
- Page 283 and 284: Troubleshooting The two most import
- Page 285 and 286: Troubleshooting points. The number
- Page 287 and 288: Security with Microsoft Domain Cont
- Page 289 and 290: mdsclientn dialog output: Troublesh
- Page 291 and 292: sessions output: *** 1/64 RPC sessi
- Page 293 and 294: APPENDIX A Legacy Hardware Platform
- Page 295 and 296: Figure 127. ContentDirector Hard Dr
- Page 297 and 298: . Figure 129. ContentDirector Power
- Page 299 and 300: Table 65. ContentDirector Indicator
- Page 301 and 302: Drive-status Indicator Pattern Cond
- Page 303 and 304: 1. Link indicator 2. Activity indic
- Page 305 and 306: Figure 139 and Table 72 describe th
Table 39. ContentServer 2124 Front Bezel LEDs (Continued)<br />
# LED Color/State Description<br />
c. Disk 1, 5, 9<br />
d. Disk 2, 6, 10<br />
e. Disk State 3, 7, 11<br />
f. Disk State 4, 8, 12<br />
Front Panel View<br />
Hardware Reference<br />
Red Indicates that the Ethernet interface is offline.<br />
The possible reasons include the following:<br />
• There is no connection<br />
• The connection may be down<br />
• The connector may need replacing<br />
White (solid) Normal state, disk online.<br />
White (blink) LED blinks during any read or write activity<br />
on disk.<br />
Red Disk is offline. It may be unmounted or it is<br />
inactive<br />
Figure 108 and Table 40 detail the front view of the ContentServer 2124 with the front bezel<br />
removed and all disk drives in place. The circled numbers on the figure identify the drive slot numbers.<br />
<strong>Omneon</strong>, Now Part of <strong>Harmonic</strong> 233