About Omneon MediaGrid - Harmonic Inc

Hardware Reference
Indicator, Button, or Connector Description
4. LCD display Provides status information and system error messages.
The LCD display lights during normal system operation.
Both the systems management software and the
identification buttons located on the front and back of the
system can cause the LCD to flash blue to identify a
particular system.
The LCD display lights amber when the system needs
attention due to a problem with power supplies, fans, system
temperature or hard drives.
Note: If the system is connected to AC power and an error
has been detected, the LCD display lights amber regardless
of whether the system has been powered on.
5. System identification button Pressing this button will cause the Front LCD display and
the system status indicator on the rear panel to blink.
6. USB connectors Use to connect the front bezel.
7. Optical drive Use for software installation.
8. Hard drive 0 Refer to Table 10 for a description of the indicator codes.
9. Hard drive 1
10. Solid state drive Available only in the High Performance ContentDirector
2000.
Drive Status LEDs
Figure 79 and Table 10 describe the drive indicators and their functions.
Drive-status Indicator (green and amber)
Drive-activity Indicator (green)
Figure 79. ContentDirector Hard Drive Indicators
Table 10. Drive-status Indicator Pattern (RAID Only)
Drive-status Indicator Pattern Condition
Blinks green two times per second Identify drive/preparing for removal
204 Installation and Configuration Guide