About Omneon MediaGrid - Harmonic Inc

Administrative Procedures
12. Power down the ContentServers and ContentStores as follows:
• ContentServer 3000 (3U)—press the red power button on the control panel on the front of the
server and hold for five seconds. Once the disk drive LEDs are off, disconnect the two power
cords from the back of the server.
• ContentStore 3160 (3U)—press the red power button on the control panel on the front of the
device and hold for five seconds. Once the disk drive LEDs are off, disconnect the two power
cords from the back of the device.
13. From the SystemManager platform, click the Start button on the taskbar, and then click Shut Down
to shut down the SystemManager platform. Disconnect the power cord if necessary.
14. Power down the Network Switches by disconnecting the power cords.
Powering Down or Restarting a Single ContentDirector
To power down a single ContentDirector:
1. From the Configuration tab, click the Servers & Switches icon in the left-hand column to open the
Servers & Switches page.
2. In the ContentDirectors section, click the name of the ContentDirector you wish to power down.
The ContentDirector Properties page appears.
3. Click the Shutdown button located at the bottom of the General Properties section.
4. When the confirmation message appears, click OK.
5. Check the Status field to verify that it indicates Not Responding. Note that this may take a few
minutes depending on the length of the discovery cycle and the status of other devices in your
network.
6. Disconnect the power supply.
To restart a single ContentDirector without removing the power supply:
1. From the ContentDirector Properties page, click the Reboot button located at the bottom of the
General Properties section.
2. When the confirmation message appears, click OK. The ContentDirector will restart.
3. Check the Status field to verify that it changes to Not Responding, and then returns to its previous
state. Note that it may take a few minutes for the status to change, depending on the length of the
discovery cycle and the status of other devices in your network.
Powering Down or Restarting a Single ContentBridge
To power down a single ContentBridge:
184 Installation and Configuration Guide