29.11.2012 Views

About Omneon MediaGrid - Harmonic Inc

About Omneon MediaGrid - Harmonic Inc

About Omneon MediaGrid - Harmonic Inc

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

System Configuration<br />

9. As the transfer occurs, you will see the following transfer progress count, frame by frame, and also the<br />

transfer speed in frames per second (fps):<br />

0 of 15000 frames copied (0.0 fps)<br />

5 of 15000 frames copied (1.7 fps)<br />

76 of 15000 frames copied (19.0 fps)<br />

138 of 15000 frames copied (27.6 fps)<br />

191 of 15000 frames copied (31.8 fps)<br />

Configuring a ContentBridge<br />

Only perform these steps if you add a ContentBridge to an already-configured <strong>Omneon</strong> <strong>MediaGrid</strong><br />

system.<br />

The ContentBridge must have a fixed (static) IP address. It is recommended that you assign an IP<br />

address from the bottom of the dynamic range and that those addresses be removed from the range.<br />

The DHCP server must also recognize the MAC address of the ContentBridge and assign it a reserved<br />

IP address during startup. The ContentBridge MAC address is located on the outside of the unit.<br />

Follow these steps to assign a static IP address to the ContentBridge. Additionally, a DNS entry must<br />

exist in the domain server for the ContentBridge. Use the following IP address range when assigning<br />

the addresses: xx.xx.xx.50-99.<br />

In the following example, “CLB0F118” is the ContentBridge host name. Make sure that the hardware<br />

Ethernet addresses match the port numbers (eth0 or eth1) and the public network addresses.<br />

To configure a ContentBridge:<br />

1. Open the /etc/dhcpd.conf file for the primary ContentDirector by typing the following:<br />

sudo vi /etc/dhcpd.conf<br />

2. Add two entries for each ContentBridge, including the following information: domain-name-servers,<br />

domain-name, subnet-mask, routers, hardware Ethernet MAC address and fixed IP address. An entry<br />

is needed for each Ethernet port on the ContentBridge.<br />

3. Type the following to synchronize the time between the ContentDirectors:<br />

ntpdate -u IP_ADDRESS<br />

where IP_ADDRESS is the IP address of a valid NTP server (preferably the SystemManager).<br />

4. Enter the following commands after editing the file:<br />

sudo service dhcpd configtest<br />

sudo service dhcpd restart<br />

<strong>Omneon</strong>, Now Part of <strong>Harmonic</strong> 137

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!