About Omneon MediaGrid - Harmonic Inc
About Omneon MediaGrid - Harmonic Inc About Omneon MediaGrid - Harmonic Inc
System Configuration 2. Type the following if DHCP is OFF: sudo /sbin/chkconfig dhcpd on 3. Type the following to synchronize the time between the ContentDirectors: ntpdate -u IP_ADDRESS where IP_ADDRESS is the IP address of a valid NTP server (preferably the SystemManager). 4. Type the following to apply the settings: sudo service dhcpd restart You should see output similar to the following: Internet Systems Consortium DHCP Server V3.0.2 Copyright 2004 Internet Systems Consortium. All rights reserved. For info, please visit http://www.isc.org/sw/dhcp/ 5. Type the following to verify that DHCP is running: sudo service dhcpd status You should see output similar to the following: sudo service dhcpd status dhcpd (pid 2365) is running... The “pid” is a process ID number, which will vary. NOTE: SystemManager provides DHCP status (running or not), as well as failover mode on the ContentDirector Properties page. See the Omneon SystemManager User Guide for details. Verifying ContentDirector and ContentServer Communication This service ensures that the ContentDirectors are communicating with the ContentServers. To verify communication: 1. Start the ContentDirector services by typing the following at the command prompt: sudo service omcld start 2. Wait a few seconds and then type the following: ps -C ssmd You should see a reply similar to the following, which verifies ssmd is running: PID TTY TIME CMD 23361 ? 00:25:48 ssmd Verifying the Metadata Maintenance Service The Metadata Maintenance Service maintains all of the file system metadata information, such as the names, directories, dates, permission, etc. 128 Installation and Configuration Guide
To verify the service: 1. Type the following at the command prompt: ps -C mdscore You should see a reply similar to the following: PID TTY TIME CMD 23452 ? 00:14:39 mdscore If the service “mdscore” is not running, the times may not be synchronized between ContentDirectors. System Configuration 2. To verify that the time and date are set on each ContentDirector, refer to Setting the Omneon MediaGrid System Time for more information. 3. Also check each ContentDirector’s actual current time by typing the following at the command prompt: date 4. If the times do not match, restart the services, and then repeat the steps above. Verifying the mdscore Service Connection To verify the connection: 1. Type the following at the command prompt to verify connection to the mdscore service: sudo /opt/omcld/bin/mdsclientn localhost Omneon, Now Part of Harmonic 129
- Page 101 and 102: System Installation with ContentSer
- Page 103 and 104: 2. Continue connecting any remainin
- Page 105 and 106: System Installation with ContentSer
- Page 107 and 108: CHAPTER 3 System Configuration This
- Page 109 and 110: Password: OVN@SvCaUsa 3. Enter the
- Page 111 and 112: System Configuration 4. If you are
- Page 113 and 114: 6. Apply power to the ContentServer
- Page 115 and 116: Notes on Active Directory Configura
- Page 117 and 118: Follow the prompts to initialize th
- Page 119 and 120: Joining an Omneon MediaGrid Cluster
- Page 121 and 122: 1. From your SSH terminal, edit /et
- Page 123 and 124: A list of users in the domain displ
- Page 125 and 126: System Configuration 1. After confi
- Page 127 and 128: 4. Type the following commands to r
- Page 129 and 130: The expected result is: Domain=[SNV
- Page 131 and 132: System Configuration This mount poi
- Page 133 and 134: System Configuration c. Replace wi
- Page 135 and 136: Modify the file as follows: System
- Page 137 and 138: Omneon MediaGrid name ContentDirect
- Page 139 and 140: Editing the LDAP Configuration File
- Page 141 and 142: System Configuration 4. Create a Sa
- Page 143 and 144: Modify the file as follows: System
- Page 145 and 146: Figure 43. Server Admin Open Direct
- Page 147 and 148: The following is a sample output fr
- Page 149 and 150: System Configuration a. Replace dom
- Page 151: System Configuration NOTE: Upon joi
- Page 155 and 156: System Configuration configurations
- Page 157 and 158: To configure the amount of memory u
- Page 159 and 160: System Configuration 4. Set the val
- Page 161 and 162: System Configuration 9. As the tran
- Page 163 and 164: The acceptable options are “YES
- Page 165 and 166: CHAPTER 4 Installing the File Syste
- Page 167 and 168: Installing the File System Driver s
- Page 169 and 170: Installing the File System Driver 3
- Page 171 and 172: CHAPTER 5 Accessing the Omneon Medi
- Page 173 and 174: Figure 45. Omneon MediaGrid Login A
- Page 175 and 176: Accessing the Omneon MediaGrid •
- Page 177 and 178: Automatically Mounting a File Syste
- Page 179 and 180: 11. Click the Browse button and the
- Page 181 and 182: Figure 53. Connect to Omneon MediaG
- Page 183 and 184: Figure 54. Automatic MediaGrid Conn
- Page 185 and 186: Accessing the Omneon MediaGrid Moun
- Page 187 and 188: Table 4. Mount Options (Continued)
- Page 189 and 190: Table 5. Mount Options (Continued)
- Page 191 and 192: Accessing the Omneon MediaGrid To u
- Page 193 and 194: Figure 58. MyDir Properties Accessi
- Page 195 and 196: Accessing the Omneon MediaGrid •
- Page 197 and 198: Using AFP on a Macintosh Client Fol
- Page 199 and 200: Accessing the Omneon MediaGrid For
- Page 201 and 202: CHAPTER 6 Administrative Procedures
To verify the service:<br />
1. Type the following at the command prompt:<br />
ps -C mdscore<br />
You should see a reply similar to the following:<br />
PID TTY TIME CMD<br />
23452 ? 00:14:39 mdscore<br />
If the service “mdscore” is not running, the times may not be synchronized between<br />
ContentDirectors.<br />
System Configuration<br />
2. To verify that the time and date are set on each ContentDirector, refer to Setting the <strong>Omneon</strong><br />
<strong>MediaGrid</strong> System Time for more information.<br />
3. Also check each ContentDirector’s actual current time by typing the following at the command<br />
prompt:<br />
date<br />
4. If the times do not match, restart the services, and then repeat the steps above.<br />
Verifying the mdscore Service Connection<br />
To verify the connection:<br />
1. Type the following at the command prompt to verify connection to the mdscore service:<br />
sudo /opt/omcld/bin/mdsclientn localhost<br />
<strong>Omneon</strong>, Now Part of <strong>Harmonic</strong> 129