About Omneon MediaGrid - Harmonic Inc

System Configuration
This mount point can be modified directly in the configuration file. However, note that the cluster
used in the NATIVE line must be configured to authenticate against the same Active Directory
domain as the ContentBridge. For instructions on editing the configuration file, refer to “Editing the
High Bandwidth ContentBridge Configuration File” in the Omneon SystemManager User Guide.
Verify Communication with the Domain Controller
Follow the steps described in Verifying Communication with the Domain Controller.
NOTE: Make sure the MediaGrid cluster is also configured with Active Directory.
NOTE: In order to access the MediaGrid, the individual users must be added to the Active Directory domain.
Joining a ContentBridge 1000B to an Active Directory Domain
Using the Manual Method
NOTE: Configuring different ContentBridges in a MediaGrid cluster with different directory access
authentication protocols (for example, ADS, LDAP, and OpenDirectory) is not supported. The following set of
steps will reset the authentication mechanism for all ContentBridges in the cluster.
Configure Samba Settings for the ContentBridge
To configure Samba settings:
1. Log on to the first ContentDirector in your system using the following user name and password:
User name: ovnuser
Password: OVN@SvCaUsa
2. Remove samba private files stored on the ContentDirector with the following command:
sudo rm -f /tftpboot/config/gateway/secrets/*
3. Generate the file, /tftpboot/config/gateway/smb.conf, as shown in Figure 41.
Omneon, Now Part of Harmonic 107