About Omneon MediaGrid - Harmonic Inc

6. Apply power to the ContentServers as follows:
System Configuration
• For a system with the ContentServer 3000:
a. Apply power to the ContentServers 3000 by connecting the power cords to power sources. Press
the Power button on the control panel on the front of the server.
b. Apply power to the ContentStores 3160 by connecting the power cords to power sources. Press
the Power button on the control panel on the front of each ContentStore.
• For the ContentServer 1042, connect the power cords to power sources and then press the
power switch on the back of the server.
• For the ContentServer 2122/2124, connect the power cords to power sources. There is no power
button on this server; the server powers on when connected to a power source.
Running the Configuration Assistant
Follow these steps to run the configuration assistant.
IMPORTANT: Make sure that the completed Omneon MediaGrid Installation Planning Guide is available
before continuing. Also make sure you have reviewed the information in Getting Started with the Omneon
MediaGrid Configuration Assistant before continuing.
To run the configuration assistant:
1. Connect a monitor and keyboard to the first ContentDirector in your Omneon MediaGrid system.
CAUTION: Do not attempt to run the Configuration Assistant remotely (for example, via
SSH). You must run the Configuration Assistant directly from the ContentDirector in order
for it to successfully configure the system.
2. Log on to the ContentDirector using the following user name and password:
• User name: ovnuser
• Password: OVN@SvCaUsa
3. Run the discover command to verify that the configuration assistant will be able to detect all of the
devices in your Omneon MediaGrid system. Enter the following:
sudo discover -c
Depending on the number of devices in your system, this process may take up to 10 minutes to detect
all the devices. See Figure 40.
Omneon, Now Part of Harmonic 89