About Omneon MediaGrid - Harmonic Inc

System Configuration
You should see the following prompt:
“Device may be rebooted, do you want to continue [y/n]?”
8. Type “y”.
You should see the following prompt:
“Press ‘Enter’ and start xmodem on your host…”
9. Press the Enter key.
10. Select Send File from the Transfer menu on the HyperTerminal menu bar.
A Send File window appears.
11. Click the Browse button to locate the switch configuration files on the USB drive in one of the
following directories: “configfiles/switches/HP3400” or “configfiles/switches/HP2900” or
“configfiles/switches/HP5400” (depending on which switch you are configuring).
12. Double-click the file “HP_subA1.cfg”, where is the switch model number (3400,
2900).
If you are configuring an HP5400 switch, select the configuration file for the type of connections, as
follows:
• For the all-1GbE port connections (regardless of the number of ports), use the
HP5400_all_1G.cfg file
• For the CX4 10GbE connections (both four and eight) on the top row of the switch, use the
HP5400_CX4.cfg file
• For the fiber 10GbE connections (both four and eight) on the top row of the switch, use the
HP5400_MMF.cfg file
NOTE: Contact Omneon Technical Support for configuration instructions if you are installing more than one
HP5400 switch.
13. Verify that Xmodem is selected as the transfer protocol.
14. Click the Send button to send the file.
The switch reboots and then closes the HyperTerminal connection.
Configuring Switch B
NOTE: If you are configuring an HP5400 switch, you can skip this section. The HP5400 combines switch A
and switch B. Configuration was completed in the previous section.
To configure switch B:
1. Remove the serial cable from switch A.
2. Connect the serial cable to switch B.
3. Repeat the steps in Configuring Switch A above, using the file “HP_subB1.cfg” for Step
12.
86 Installation and Configuration Guide