About Omneon MediaGrid - Harmonic Inc
About Omneon MediaGrid - Harmonic Inc About Omneon MediaGrid - Harmonic Inc
• Route power cords and other cables so that they are not likely to be damaged. Disconnect power before cleaning. Do not use liquid or aerosol cleaners; use only a damp cloth. • Dangerous voltages exist at several points in this product. To avoid personal injury, do not touch exposed connections and components while power is on. Do not insert anything into either of the system’s two power supply cavities with power connected. • Do not wear hand jewelry or watches when troubleshooting high current circuits, such as the power supplies. • To avoid fire hazard, use only the specified correct type, voltage and current rating as referenced in the appropriate parts list for this product. Always refer fuse replacement to qualified service personnel. • Before working on a system that does not have an on/off switch, unplug all power supply cords. • Attention: Avant de travailler sur un système non équipé d'un commutateur marche-arrêt, débrancher le cordon d'alimentation de toute source d'alimentation. Cautions Please observe the following important cautions: • When installing this equipment, always comply with the National Electrical Standard and local electrical standard for attachment of the power cords. • Risk of explosion if battery is replaced incorrectly or with an incorrect type. There are no user-serviceable batteries inside Omneon products. Refer to Omneon qualified personnel only to service the replaceable batteries. Dispose of batteries according to the instructions. • Use only specified replacement parts. • Follow static precautions at all times when handling this equipment. • Slots and openings in the chassis are provided for ventilation. Do not block them. Leave the back of the frame clear for air exhaust cooling and to allow room for cabling — a minimum of 6 inches (15.25 cm) of clearance is recommended. Safety and Regulatory Information for the ContentServer 3000 and ContentStore 3160 Danger: Class 1 laser product. Attention: Produit laser de classe 1 Warnung: Laserprodukt der Klasse 1 This equipment contains optical transceivers, which comply with the limits of Class 1 laser radiation. Visible and invisible laser radiation may be emitted from the aperture of the optical transceiver ports when no cable is connected. Avoid exposure to laser radiation and do not stare into open apertures. Lithium Battery Notice for Service Personnel This product contains a lithium battery. Although the battery is not field-serviceable, observe the following warning: x Installation and Configuration Guide
CAUTION: Danger of explosion if battery is replaced with incorrect type. Replace only with the same type recommended by the manufacturer. Dispose of used batteries according to the manufacturer's instructions. ATTENTION: II y a danger d'explosion s'il a remplacement incorrect de la batterie. Remplacer uniquement avec une batterie du meme type ou d'un type equivalent recommande par le constructeur. Mettre au rebut les batteries usagees conformement aux instructions du fabricant WARNUNG: Bei Einsetzen einer falschen Batterie besteht Explosionsgefahr. Ersetzen Sie die Batterie nur durch den gleichen oder vom Hersteller empfohlenen Batterietyp. Entsorgen Sie die benutzten Batterien nach den Anweisungen des Herstellers. WARNING: This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that a fuse or circuit breaker no larger than 120 VAC, 15A U.S. (240 VAC, 10A international) is used on the phase conductors (all current-carrying conductors). ATTENTION: Pour ce qui est de la protection contre les courts-circuits (surtension), ce produit dépend de l'installation électrique du local. Vérifier qu'un fusible ou qu'un disjoncteur de 120 V alt., 15 A U.S. maximum (240 V alt., 10 A international) est utilisé sur les conducteurs de phase (conducteurs de charge). WARNUNG: Dieses Produkt ist darauf angewiesen, daß im Gebäude ein Kurzschluß- bzw. Überstromschutz installiert ist. Stellen Sie sicher, daß eine Sicherung oder ein Unterbrecher von nicht mehr als 240 V Wechselstrom, 10 A (bzw. in den USA 120 V Wechselstrom, 15 A) an den Phasenleitern (allen stromführenden Leitern) verwendet wird. Omneon, Now Part of Harmonic xi
- Page 1 and 2: Omneon MediaGrid Installation and C
- Page 3 and 4: FCC Compliance This equipment has b
- Page 5 and 6: Parameter Specification Detail Safe
- Page 7 and 8: Parameter Specification Detail EMC
- Page 9: Network Switch 2924, 2948 and 5406
- Page 13 and 14: • Storage Temperature -104 °F to
- Page 15 and 16: Contents Introduction . . . . . . .
- Page 17 and 18: Contents Private VLANs . . . . . .
- Page 19 and 20: Contents Joining a ContentBridge 10
- Page 21 and 22: Contents About Access Control Lists
- Page 23 and 24: Contents Front Panel View . . . . .
- Page 25 and 26: Omneon MediaGrid Version 3.1.1 Intr
- Page 27 and 28: • Cluster, in the context of an O
- Page 29 and 30: Two models of ContentDirectors are
- Page 31 and 32: Keep in mind the following addition
- Page 33 and 34: 1. From Windows, click the Start bu
- Page 35 and 36: 1. Add two registry parameters to t
- Page 37 and 38: CHAPTER 1 System Installation with
- Page 39 and 40: ContentBridge (optional) SystemMana
- Page 41 and 42: • Cluster names and device names
- Page 43 and 44: Public VLAN Private VLAN 1 Private
- Page 45 and 46: Public VLAN Private VLAN 1 Private
- Page 47 and 48: 16 5x(2+1)+1 500 GB 5 TB 16 5x(2+1)
- Page 49 and 50: System Installation with ContentSer
- Page 51 and 52: System Installation with ContentSer
- Page 53 and 54: System Installation with ContentSer
- Page 55 and 56: System Installation with ContentSer
- Page 57 and 58: Figure 10. ContentServer 3000 and 1
- Page 59 and 60: System Installation with ContentSer
• Route power cords and other cables so that they are not likely to be damaged. Disconnect power before<br />
cleaning. Do not use liquid or aerosol cleaners; use only a damp cloth.<br />
• Dangerous voltages exist at several points in this product. To avoid personal injury, do not touch exposed<br />
connections and components while power is on. Do not insert anything into either of the system’s two<br />
power supply cavities with power connected.<br />
• Do not wear hand jewelry or watches when troubleshooting high current circuits, such as the power<br />
supplies.<br />
• To avoid fire hazard, use only the specified correct type, voltage and current rating as referenced in the<br />
appropriate parts list for this product. Always refer fuse replacement to qualified service personnel.<br />
• Before working on a system that does not have an on/off switch, unplug all power supply cords.<br />
• Attention: Avant de travailler sur un système non équipé d'un commutateur marche-arrêt, débrancher le<br />
cordon d'alimentation de toute source d'alimentation.<br />
Cautions<br />
Please observe the following important cautions:<br />
• When installing this equipment, always comply with the National Electrical Standard and local electrical<br />
standard for attachment of the power cords.<br />
• Risk of explosion if battery is replaced incorrectly or with an incorrect type. There are no user-serviceable<br />
batteries inside <strong>Omneon</strong> products. Refer to <strong>Omneon</strong> qualified personnel only to service the replaceable<br />
batteries. Dispose of batteries according to the instructions.<br />
• Use only specified replacement parts.<br />
• Follow static precautions at all times when handling this equipment.<br />
• Slots and openings in the chassis are provided for ventilation. Do not block them. Leave the back of the<br />
frame clear for air exhaust cooling and to allow room for cabling — a minimum of 6 inches (15.25 cm) of<br />
clearance is recommended.<br />
Safety and Regulatory Information for the ContentServer 3000 and ContentStore 3160<br />
Danger: Class 1 laser product.<br />
Attention: Produit laser de classe 1<br />
Warnung: Laserprodukt der Klasse 1<br />
This equipment contains optical transceivers, which comply with the limits of Class 1 laser radiation.<br />
Visible and invisible laser radiation may be emitted from the aperture of the optical transceiver ports<br />
when no cable is connected. Avoid exposure to laser radiation and do not stare into open apertures.<br />
Lithium Battery Notice for Service Personnel<br />
This product contains a lithium battery. Although the battery is not field-serviceable, observe the<br />
following warning:<br />
x Installation and Configuration Guide