Positioning System HIWIN - Industrial Technologies

More documents

Recommendations

Info

Индастриал Технолоджис www.ind-techno.com.ua +38 044 498 21 94Positioning SystemsCustomized Positioning Systems1.2 Typical Dimensions1.2.1 Winding-independent dimensions1.2.2 Winding-dependent dimensionsF aF cF pK mP vP vpP cTRelative constant force between primary and secondary part (magneticbasis) that must be handled by a mechanical guide.Motor power, which is available in nominal operation as continuous forceand which results in warming to 90 °C above ambient temperature.Motor power that can be generated for a short time, which is reachedat I p at the end of the linear modulation range and resultsin substantial heating up when there is no cooling.Motor constant, which expresses the ratio of generated power and dissipationpower and consequently the degree of effectiveness.The heat output created in the motor winding, which results in a time-dependenttemperature rise dependent on the operating mode (current) and the ambientconditions (cooling) In the upper control P v is especially high in the upper modulationrange (at I p ) due to the quadratic dependency of current, while only relatively slightwarming occurs in the range of the nominal current. P v is calculated using themotor constant K m for a movement section with the required force F: P v = F / K m2Peak dissipation power at I pDissipation power at I cPermissible winding temperature, which is recorded by sensorsor thermal circuit breakers; the created motor surface temperatureis dependent onthe actual installation conditions (table size)the heat dissipation conditions (cooling)the operating mode and consequently the mean performance entrycan only be determined if these variables are known.I cI pK fK uFor generating the current connected for continuous force.For short-term generation of the peak force of connected peak current.Winding dimension, which produces the created force with the current:F = I × K fWinding dimension, which results dependent on the speedcreated in the motor terminalsingenerator operation: U g = K u × vR 25 Winding resistance at 25 °C; this increasesto approx. 1.2 times the value at 80 °C.Industrial Technologies4
Индастриал Технолоджис www.ind-techno.com.ua +38 044 498 21 942. Linear Motors2.1 Product overview 62.2 Typical characteristics of Linear Motors 82.3 Scope of delivery 92.4 Drive Amplifier for Linear Motors 102.5 System Configuration 112.6 Model Numbers 122.7 LMX1E Linear Motors 152.8 LMX1L-S Linear Motors 222.9 LMX1L-T Linear Motors 362.10 LMV1L Linear Motors 382.11 LMH1L Linear Motors 402.12 X-Y Stages 432.13 Gantry systems 472.7 2.8 2.92.10 2.11 2.12Industrial Technologies2.135
Page 1 and 2: Индастриал Техноло
Page 7: Индастриал Техноло
Page 59 and 60:
Индастриал Техноло
Page 61 and 62:
Page 63 and 64:
show all

Positioning System HIWIN - Industrial Technologies

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?