Model SEQ

Installation InstructionsThe cable supplied with your SEQ is comprised of seven wires. Theseseven wires are terminated on one end in a connector designed to beinserted into the back of the SEQ. The other wire ends have been leftunterminated.The following are instructions on proper connection of the sevenunterminated wire ends and additional wiring to ensure proper systemgrounding.WIRES INSIDE SHIELDED CABLE:Five wires are contained within the gray jacketed, shielded cable.Signal inputs (to SEQ), outputs (from SEQ) & signal ground are allcontained within the shielded cable. Function & connection of thesewires are as follows unless otherwise indicated on a tag attached to thecable:Green - Right Channel Input(to SEQ from right channel output of source unit)White - Left Channel Input(to SEQ from left channel output of source unit)Red - Right Channel Output(from SEQ to right channel input of amplifier)Black - Left Channel Output(from SEQ to left channel input of amplifier)Bare - Signal Ground(from shielded cable to case of source unit)*WIRES EXTERNAL TO SHIELDED CABLE:Two wires are external to the gray jacketed, shielded cable.Power Input & Power Ground connections are external to the shieldedcable. Function & connection of these wires are as follows:Red - Power Input to SEQ(connect to constant, ‘unswitched’, 12V source - fused)**Black - Power Ground(connect to case of source unit)*4