Answer Solutions Specification Guide - OEC Business Interiors

Stability Guidelines, continuedGuidelines for Answer Off-Module Bracket ConfigurationsPanels with Components24" min30" min10' max12' max24" min“U” Configuration Single post leg at centerIn a 12' run using an Answer can be eliminated if an endoff-modular connector bracket, panel, side support brackets,a cantilever must be used with or cantilever with post leg isthe connector bracket. The used with off-module bracket.other end needs to be supportedwith a full height panel,end panel, or a pedestal withfiller. For 24"D worksurfaces,the center can be supportedby a cantilever. 30"D straightand transition worksurfacesrequire additional floor support48" min60" minalong the front edge, such asa pedestal or post leg. A cantileverand single post legmust be used when hangingcomponents on one side only.10' maxAll components are Answer.“T” ConfigurationIn a 10' or 12' run using anAnswer off-modular connectorbracket, an end panel must beused with the connectorbracket. The other end needs24" minto be supported with a fullheight panel, end panel, or a24" minpedestal with filler. For 24"Dworksurfaces, the center canbe supported by a cantileverwhen bins and worksurfacesare used on both sides (asshown). 30"D straight andtransition worksurfacesrequire additional floor supportalong the front edge, such asa pedestal or post leg. A cantileverand single post legmust be used when hangingcomponents on one side only..All components are Answer.30" min12' max30" min30" min.60 Answer Solutions Specification Guide