Answer Solutions Specification Guide - OEC Business Interiors

Off-Module Panel ConnectorConnections24" maximum.Off-module fin wallmust always be the sameheight, or shorter than thespine wall.Fin wall can be no morethan 24" shorter than thespine wall. If there is morethan a 24" difference, anadditional horizontal barmust be added to the spinewall at the same height asthe fin wall. A stacking horizontalframe kit must beused.Spine wall skins mustbe segmented with a seammatching the height of theshorter fin wall. This allowsaccess to the top bracketand the spine wall horizontalbar.When stacking on thefin panel, the spine wallskins must be segmentedwith a seam matching theheight of the fin base panel.When stacking wallstart junctions in an offmoduleapplication, the offmodulepanel connectorconnects to the base wallstart junction.Two off-module panelscan be connected back toback at the same location..When connecting twooff-module fins at differentheights oneither side of the spinepanel, an additional horizontalbar must be orderedand installed at the sameheight of the shorter finpanel.4"3"An off-module fin wallcannot connect flush to theend of a panel in the spinewall. The closest connectionpoint will leave a 3" tail onthe spine including the endof run trim.An off-module fin wallcannot attach at a junctionin the spine wall. There is a2" area of dead space oneither side of the junctionrendering a total of 4" deadspace.An off-module fin wallcannot be installed over awindow that is located at thetop of a spine panel..Wiring & CablingWiring and cablingcomponents cannot berouted internally from aspine wall to an off-modulefin wall without cutting openingsin the spine wall skin.Tip: It is recommended thatyou route wiring and cablingthrough the spine wall.Internode power componentsshould be used tobring power from the spinewall to the workstation..Surface MaterialsOff-module bracket• Black paintTip: Bracket is hidden whenproperly installed.Off-module installationrequires field modificationof the light seal on the topskin. Surface covering is noteffected..Application TopicsStability Guidelinesfor Application RulescPage 47Stacking junctionscan be used with any heightbase junction.Bins, shelves, andworksurfaces cannot beattached off-module..PanelsAnswer Solutions Specification Guide 27