Answer Solutions Specification Guide - OEC Business Interiors

Panel-Mounted AnswerWorksurface SupportsLeftShared.Corner bracket isincluded as standard onAnswer corner and extendedcorner worksurfaces. It connectsthe back corner of worksurfaceto panel.RightCantilevers support worksurfacesat any height in 1"increments. Cantilever isnon-handed and can beused to support either end ofa worksurface, or shared tosupport two worksurfaces atthe same height simultaneously.One tie plate shipswith each cantilever.30"D straight and transitioncantileveredworksurfaces requireadditional floor supportalong the front edge, suchas a pedestal, end panel,post leg, side supportbracket, or an adjacentreturn worksurface..Adjacent cantileveredworksurfaces must bethe same height in order toconnect with a tie plate andprovide panel stability.Tip: Answer panel junctionscan accommodate only onesupport at each worksurfaceseam.Center support panel isan alternative to a cantileverin supporting longer runs ofworksurfaces for additionalpanel stability. Refer to theapplicable panel stabilityguidelines for specificrequirements.Center support panelsare available in seated andstanding heights, and cannotbe used in freestandingapplications or as a substitutefor an end panel. Onetie plate ships with eachcenter support panel.End panels can be usedto support the end of aworksurface for additionalpanel stability. Refer to theapplicable panel stabilityguidelines for specificrequirements.End panels are availablein seated and standingheights, and cannot be usedin freestanding applications..All panel mounted supportscan be removed andrepositioned later withoutany permanent damage topanels or skins.Pedestals with a filler canbe used to support the endof a worksurface in place ofan end panel.cPage 27757"WReinforcing channel(TS7WKSPT) is used toreinforce all worksurfaceswith 60" or more of unsupportedkneespace.cSpecifying, page 137.Surface MaterialsSide support bracketand reinforcingchannel• Black paint onlyCantilever, centersupport panel, andend panel• Paint.Application TopicsWorksurfaces usedin panel-supportedinstallations must followapplicable panel stabilityguidelines.cPage 47.WorksurfacesAnswer Solutions Specification Guide 195